USING YOUR REMOTE
TO CONTROL VCR/PVR FUNCTIONS
Operating the precoded function for your VCR/PVR (Personal Video Recorder).
This remote is designed to operate different types of VCRs/PVRs. You must first program the remote to match the remote system of your VCR/PVR (refer to pages
1.Turn ON your VCR/PVR.
2.Aim the remote control at the front of your VCR/PVR.
3.To switch to VCR/PVR
4.Hold down the ENT button on the remote and enter the four digit preset code that matches your VCR/PVR, as shown on pages 48- 49. Release the ENT button. The indicator light will flash 3 times if the code was accepted.
5.Aim the remote at the VCR/PVR and press the POWER button. The remote will turn off your PVR when the correct four digit pre- set code is entered. When this occurs, the remote control is programmed for your VCR/PVR. If the VCR/PVR does not turn off, try a different four digit preset code.
6.The remote will now control your VCR/PVR.
NOTES:
1.If your PVR cannot be operated after performing the above procedures, your PVR’s code has not been precoded into the remote.
2.In the unlikely event that your PVR cannot be operated after performing the above procedures, please consult your PVR operating guide.
3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.
4.VCR precode library is included in the PVR mode. Default device for this mode is Hitachi VCR.
5.INFO, GUIDE and LC (Last Channel) buttons are for PVR devices, not for VCR.
aPRECODED VCR/PVR Buttons
These buttons transmit the chosen precoded VCR/PVR codes.
bEXCLUSIVE TV Buttons
These buttons are for operating the TV.
a
b
A/V NET
GUIDE
b
a |
a |
a |
a |
THE REMOTE CONTROL
MY VCR/PVR CODE IS:
NOTE: Refer to instruction manual of the VCR/PVR for operation of the buttons exclusively for the VCR/PVR.
45