Hitachi 43FDX15B, 53SDX20BB Using the Remote to Control DVD Functions, Precoded DVD Buttons

Page 28

USING THE REMOTE TO CONTROL DVD FUNCTIONS

Operating the precoded function for your DVD player.

This remote is designed to operate different types of DVD players. You must first program the remote to match the remote system of your DVD player. (refer to page 29 for pre-codes)

1.Turn ON your DVD player.

2.Aim the remote control at the front of your DVD player.

3.Press and release the DVD/VCR button to switch to DVD pre-coded mode.

4.Hold down the DVD/VCR button on the remote and enter the two digit preset code that matches your DVD player, as shown on page 29.

5.Aim the remote at the DVD player and press the POWER button. The remote will turn off your DVD player when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your DVD player. If the DVD player does not turn off, try a different two digit preset code.

6.The remote will now control your DVD player.

NOTES:

1.If your DVD player cannot be operated after performing the above procedures, your DVD player’s code has not been precoded into the remote.

2.In the unlikely event that your DVD player cannot be operated after performing the above procedures, please consult your DVD player operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

 

POWER

TV

CBL/SAT DVD/VCR

PIP

SWAP PIP MODE

FREEZE

HELP

PIP CH

MENU

 

SELECT

MUTE

LAST CH

 

EXIT

VOL CH

DVD/VCR Button

This button allows the remote to control your DVD player by setting it to DVD mode.

PRECODED DVD Buttons

These buttons transmit the chosen precoded DVD codes.

EXCLUSIVE TV Buttons

These buttons are for operating the TV.

1 2 3

4 5 6

7 8 9

ANT 0 STATUS

VID1

VID2

VID3

VID4

REC

 

ASPECT

MODE

 

VID5

 

 

CLU-4322UG

MY DVD PLAYER CODE IS:

NOTE: Refer to instruction manual of the DVD player for operation of the buttons exclusively for the DVD player.

28

Image 28
Contents Important Safety Instructions First Time USE Remote Control Ultratec BIT-MAPON-SCREEN Display Useful Information IndexImportant Safety Instructions Safety Points YOU should Know about Your Hitachi TelevisionPrevention of Pattern Burn Public Viewing of Copyrighted MaterialAccessories Remote ControlHOW to SET UP Your NEW Hitachi Projection TV AntennaLocation ViewingHOOK-UP Cables and Connectors Antenna Connections to Rear Jack PanelFront Panel Controls Power light Remote Control sensorPerfect Picture sensor Magic FocusFront Panel Jacks and Connections Input OutputRear Panel Jacks Monitor OUTComponent Y-PBPRInputs Typical FULL-FEATURE Setup Rear Panel ConnectionsTips on Rear Panel Connections Tips on Rear Panel ConnectionsConnecting External Audio Amplifier Connecting External Audio SourcesRear Panel of Television Connecting a Monaural Audio Source to INPUT1~INPUT5 Connecting External Video SourcesBefore Operating External Video Source Connecting a Stereo Source to INPUT1~INPUT5 VCRConnecting AN S-VIDEO Source to Input 1, 2 Rear Panel of TelevisionConnecting a Component Source to Video 4 or 5 Y-PBPR DVD PlayerAspect Button HOW to USE the Remote to Control Your TV VOLUME, Mute buttonPICTURE-IN-PICTURE buttons Help buttonMode button VID1 ~ VID5 buttonsAspect button Status buttonPIP CH button Last Channel Last CH buttonMenu button PICTURE-IN-PICTURE PIP Single Mode PIPPIP button PICTURE-IN-PICTURE Surf Mode PIP PIP Mode buttonSwap button SingleFreeze button With PIP on Freeze button With PIP OFFSingle Freeze Strobe FREEZEwith PIP offUsing the Remote to Control VCR Functions Operating the precoded function for your VCRDVD/VCR Button Precoded VCR ButtonsCable CBL/SAT button Using the Remote to Control CABLE/SATELLITE BOX FunctionsPrecoded CABLE/SATELLITE BOX buttons Operating the precoded function for your DVD player Using the Remote to Control DVD FunctionsPrecoded DVD Buttons CABLE, SATELLITE, VCR, and DVD Codes Ultratec OSD Setup Customize Video Audio Theater SET UP SET Menu LanguagePlug & Play Plug & PlaySET ANTENNA/CABLE Reception BandSET Channel Memory Edit Channel Memory View Channel List SET the Clock Magic Focus Picture Formats PositionSignal Picture FormatsComp Color Type Video DisplayCustomize Name the ChannelName the Inputs Name the InputsSET Favorite Channels Favorite Channels Operation SET Parental Locks CursorMotion Picture Rating Chart Movie RatingsTV Parental Guide Rating Chart TV RatingsCanadian English Ratings Chart Canadian Ratings ENGCanadian French Ratings Chart Canadian Ratings FRNProgramming is not suitable for children Programming restricted to adults ContainsSET Program Timer CursorVideo Input Sensor Closed Caption DisplayMode ChannelContrast Brightness Color Tint Sharpness Reset VideoAdvanced Settings Color TemperaturePerfect Picture Auto ColorTreble BassBalance MTS Mode Auto Noise CancelPerfect Volume Internal SpeakersTheater Theater ModesSurround OFF SurroundTechnology Care of Your Hitachi Projection TV Your Remote Control Do notReception Problems Ignition NoiseUseful Info Inputs Outputs43FDX20B 53FDX20B 53SDX20BBHitachi Home Electronics DivisionPage Page QR52481