Hitachi 53SDX20BB HOW to SET UP Your NEW Hitachi Projection TV, Antenna, Location, Viewing

Page 5

HOW TO SET UP YOUR NEW HITACHI PROJECTION TV

ANTENNA

Unless your TV is connected to a cable TV system or to a centralized antenna system, a good outdoor color TV antenna is recommended for best performance. However, if you are located in an exceptionally good signal area that is free from interference and multiple image ghosts, an indoor antenna may be sufficient.

LOCATION

Select an area where sunlight or bright indoor illumination will not fall directly on the picture screen. Also, be sure that the location selected allows a free flow of air to and from the perforated back cover of the set.

To avoid cabinet warping, cabinet color changes, and increased chance of set failure, do not place the TV where temperatures can become excessively hot, for example, in direct sunlight or near a heating appliance, etc.

VIEWING

The major benefit of the HITACHI Projection Television is its large viewing screen. To see this large screen at its best, test various locations in the room to find the optimum spot for viewing.

The best picture is seen by sitting directly in front of the TV and about 10 to 18 feet from the screen. Picture brightness decreases as the viewer moves to the left and right of the receiver.

During daylight hours, reflections from outside light may appear on the screen. If so, drapes or screens can be used to reduce the reflection or the TV can be located in a different section of the room.

If the TV’s audio output will be connected to a Hi-Fi system’s external speakers, the best audio performance will be obtained by placing the speakers equidistant from each side of the receiver cabinet and as close as possible to the height of the picture screen center. For best stereo separation, place the external speakers at least four feet from the side of the TV, place the surround speakers to the side or behind the viewing area. Differences in room sizes and acoustical environments will require some experimentation with speaker placement for best performance.

 

 

￿

 

 

￿￿￿￿￿￿￿￿￿￿

 

￿￿￿￿￿

 

 

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿

￿￿

￿￿￿￿￿

￿￿

￿￿￿￿

￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿

￿￿￿ ￿￿￿ ￿￿￿

￿

 

￿￿

 

 

￿￿￿￿￿￿￿￿￿￿

 

 

 

 

￿￿

￿￿

￿￿￿

￿￿￿

￿￿￿

￿

￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿

￿

CAUTION: Magnetic fields, such as those of external speakers, may cause the picture to distort if they are placed too close to the television. Move the magnetic field source away from the television until there is no picture distortion.

5

Image 5
Contents Ultratec BIT-MAP Important Safety Instructions First Time USE Remote ControlON-SCREEN Display Useful Information IndexSafety Points YOU should Know about Your Hitachi Television Important Safety InstructionsPublic Viewing of Copyrighted Material Prevention of Pattern BurnRemote Control AccessoriesAntenna HOW to SET UP Your NEW Hitachi Projection TVLocation ViewingAntenna Connections to Rear Jack Panel HOOK-UP Cables and ConnectorsFront Panel Controls Remote Control sensor Power lightPerfect Picture sensor Magic FocusInput Output Front Panel Jacks and ConnectionsMonitor OUT Rear Panel JacksComponent Y-PBPRInputs Rear Panel Connections Typical FULL-FEATURE SetupTips on Rear Panel Connections Tips on Rear Panel ConnectionsRear Panel of Television Connecting External Audio SourcesConnecting External Audio Amplifier Before Operating External Video Source Connecting External Video SourcesConnecting a Monaural Audio Source to INPUT1~INPUT5 VCR Connecting a Stereo Source to INPUT1~INPUT5Rear Panel of Television Connecting AN S-VIDEO Source to Input 1, 2DVD Player Connecting a Component Source to Video 4 or 5 Y-PBPRAspect Button VOLUME, Mute button HOW to USE the Remote to Control Your TVPICTURE-IN-PICTURE buttons Help buttonVID1 ~ VID5 buttons Mode buttonAspect button Status buttonMenu button Last Channel Last CH buttonPIP CH button PIP button Single Mode PIPPICTURE-IN-PICTURE PIP PIP Mode button PICTURE-IN-PICTURE Surf Mode PIPSwap button SingleFreeze button With PIP OFF Freeze button With PIP onSingle Freeze Strobe FREEZEwith PIP offOperating the precoded function for your VCR Using the Remote to Control VCR FunctionsDVD/VCR Button Precoded VCR ButtonsPrecoded CABLE/SATELLITE BOX buttons Using the Remote to Control CABLE/SATELLITE BOX FunctionsCable CBL/SAT button Precoded DVD Buttons Using the Remote to Control DVD FunctionsOperating the precoded function for your DVD player CABLE, SATELLITE, VCR, and DVD Codes Ultratec OSD Setup Customize Video Audio Theater SET Menu Language SET UPPlug & Play Plug & PlayReception Band SET ANTENNA/CABLESET Channel Memory Edit Channel Memory View Channel List SET the Clock Magic Focus Position Picture FormatsPicture Formats SignalVideo Display Comp Color TypeName the Channel CustomizeName the Inputs Name the InputsSET Favorite Channels Favorite Channels Operation Cursor SET Parental LocksMovie Ratings Motion Picture Rating ChartTV Ratings TV Parental Guide Rating ChartCanadian Ratings ENG Canadian English Ratings ChartCanadian Ratings FRN Canadian French Ratings ChartProgramming is not suitable for children Programming restricted to adults ContainsCursor SET Program TimerVideo Input Sensor Display Closed CaptionMode ChannelVideo Contrast Brightness Color Tint Sharpness ResetColor Temperature Advanced SettingsPerfect Picture Auto ColorBalance BassTreble Auto Noise Cancel MTS ModePerfect Volume Internal SpeakersTheater Modes TheaterTechnology SurroundSurround OFF Do not Care of Your Hitachi Projection TV Your Remote ControlIgnition Noise Reception ProblemsUseful Info Outputs Inputs43FDX20B 53FDX20B 53SDX20BBHome Electronics Division HitachiPage Page QR52481