Samsung HCM4215W, HCM 422W, HCM 4216W manual Risk of Electric Shock Do not Open

Page 2

Warning! Important Safety Instructions

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

This symbol indicates high voltage is present inside. It is dangerous to make any kind of contact with any inside part of this product.

This symbol alerts you that important literature concerning operation and maintenance has been included with this product.

Note to CATV system installer: This reminder is provided to call CATV system installer’s attention to Article 820-40 of the National Electrical Code (Section 54 of Canadian Electrical Code, Part I), that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical.

Caution: FCC/CSA regulations state that any unauthorized changes or modifica- tions to this equipment may void the user’s authority to operate it.

Caution: To prevent electric shock, match the wide blade of plug to the wide slot, and fully insert the plug.

Attention: pour eviter les chocs electriques, introduire la lame le plus large de la fiche dans la borne correspondante de la prise et pousser jusqu’au fond.

Important: One Federal Court has held that unauthorized recording of copyrighted TV programs is an infringement of U.S. copyright laws.

Certain Canadian programs may also be copyrighted and any unauthorized recording in whole or in part may be in violation of these rights.

To prevent damage which may result in fire or electric shock hazard, do not expose this appliance to rain or moisture.

Image 2

Contents Owner’s Risk of Electric Shock Do not Open Thank You for Choosing Samsung Example Antenna Grounding Safety Operation InstallationYour New TV Special Features TroubleshootingList of Features Chapter OneFamiliarizing Yourself with The TV ´ Video Input jack Using the Component ShelfFront or Side Panel Jacks Audio Input jacks´ AUDIO-VIDEO Monitor Output jacks Rear Panel JacksAntenna terminals ¨ Audio Input jacks Video Input jacks´ +100 Remote ControlPower StillMain¿ S.Mode ± Mode˘ R.surf ¸ P.ModeConnecting VHF and UHF Antennas Antennas with 300-ohm Flat Twin LeadsSeparate VHF and UHF Antennas Connecting Cable TVAntennas with 75-ohm Round Leads Cable without a Cable BoxThis terminal might be labeled Connecting to a Cable Box that Descrambles Some ChannelsCable with a Cable box that Descrambles All Channels ANT IN, VHF IN, or simply,Install AT I O N Connecting a VCR Connecting a Camcorder Connecting a Second VCR to Record from the TVConnecting a DVD Player, DTV Set-Top Box 480i, 480p Connecting to Y, PB, PRConnecting a DTV Set-Top Box 480p Make sure to match the + Installing Batteries in the Remote ControlInstall two AAA size batteries Replace the cover Press the Power button Plug & Play FeatureYou can also use the Power button on the front panel Turning the TV On and OffCH or CH button. refer to Setting the clock on 1Press the Menu buttonFocus by pressing the Perfect Focus button Using the Perfect Focus FeatureYou can also select Perfect Adjusting Manual Convergence Adjust Red Convergence If a horizontal red line is visible, useViewing the Display Viewing the Menus and On-Screen DisplaysViewing the Menus Selecting a Menu Language Selecting the Antenna InputSelecting the Video Signal-source Memorizing the ChannelsAdding and Erasing Channels Manual Method Storing Channels in Memory Automatic MethodTV automatically cycles Using the Previous Channel Using the Channel ButtonsUsing the Number Buttons Changing ChannelsCan be set as Favorite channels Selecting Your Favorite ChannelsTo Store Your Favorite Channels To View Your Favorite ChannelsAdding and Erasing Channels Manual Method Press CH or CH to tune to the channel that will be labeled Labeling in the A/V modeLabeling the Channels Select Channel, thenCustomizing the Picture After adjusting an item,Picture Control Gauge will automatically disappearafter about 4 secondsUsing Automatic Picture Settings Press the Menu button. Picture icon will be high- lightedSound Control Adjusting the VolumeUsing Mute Selecting the Color ToneCustomizing the Sound Press the Menu button exitUsing Automatic Sound Settings When selecting the hours, be Setting the ClockOption 1 Setting the Clock Manually Sure to select the proper time of day AM or PMPress the Menu Press the VOL + button to select Auto clock set OnPress the CH button to select Time Zone Press the VOL + or VOL button to adjust the fine tuning Fine Tuning ChannelsAfter you adjust the fine tuning Star icon*will appearDigital Noise Reduction Wide TV Changing the Screen Size43 TV Press the Aspect button to change the screenUsing the R.surf feature Select Function, then Setting the On/Off TimerBefore using the timer, you must Select Off during this step Setting the Sleep TimerTo deactivate the On time If no function buttonsExtra sound settings Surround, Auto Volume, Melody, BBE SurroundQuick way to access the MTS Choosing a Multi-Channel Sound MTS SoundtrackSelect Mode, then press Viewing Closed CaptionsDifferent channels and fields Select Caption or TextViewing Picture-in-Picture Quick way to access the PIPMenu Simply press the PIP button on the remote control Activating Picture-in-PictureQuick way to access the signal Selecting a Signal Source Antenna or Cable for PIPSelecting a Signal Source External A/V for PIP Image is the same as the main imageSwapping the Contents of the PIP Image and Main Image Changing the Size of the PIP WindowChanging the PIP Channel Simply press the PIP CH button on the remote controlChanging the Location Rotating in PIP mode Scanning the Available ChannelsQuick way to access the V-Chip Using the V-ChipSetting Up Your Personal ID Number PIN Menu Simply press the V.Chip button on the remote controlHow to Enable/Disable the V-Chip How to Set up Restrictions Using the TV guidelinesParent Guidance TV Guidelines screen will appearGeneral audience TV-14Or CH Mpaa rating screen will appear Highlighted blinking Viewing the DemonstrationPicture icon will be Select DemonstrationRemote control has four Customizing Your Remote ControlSetting Up Your Remote Control to Operate Your VCR or DVD Make sure you enter 3 digitsSetting Up Your Remote Control to Operate Your Cable Box Codes VCR CodesCable Box DVD CodesIdentifying Problems Chapter FiveSpecifications Cleaning and Maintaining Your TVUsing Your TV in Another Country