Rear Panel Jacks, Monitor OUT | Hitachi 42V525 manual

REAR PANEL JACKS

FIRST TIME USE

ANT A

CONVERTER

	ANT B		INPUT 2	INPUT 1
			INPUT 2	INPUT 1
			Y/	Y/
MONITOR OUT	INPUT 4	INPUT 3	VIDEO	VIDEO
MONITOR OUT	INPUT 4	INPUT 3
S-VIDEO
			PB	PB
			PR	PR
VIDEO
	(MONO)	(MONO)	(MONO)	(MONO)
L
AUDIO		TV AS CENTER
R
AUDIO
TO HI-FI

HDMI 1

RS232C

1 2 3 4 5

6 7 8 9

Antenna Input/Output

The remote control allows you to switch between two separate 75-Ohm RF antenna inputs, ANT A and ANT B. ANT A input can be displayed as a main picture or sub-picture. ANT B can only be displayed as a main picture. (ANT B cannot be displayed as a sub-picture.) The antenna output labeled “TO CONVERTER” allows the ANT A connection to pass directly to a different source such as a cable box, only when ANT B is displayed as a main picture.

Audio/Video Inputs 1, 2, 3 and 4

By using the INPUTS button and CURSOR buttons of the remote control you can select each video source. Use the audio and video inputs to connect external devices, such as VCRs, camcorders, laserdisc players, DVD players etc. (If you have mono sound, insert the audio cable into the left audio jack.)

NOTE: You may use VIDEO or S-VIDEO inputs to connect to INPUT 3 and 4, but only one of these inputs may be used at a time.

MONITOR OUT

These jacks provide fixed or variable audio and video signals which are used for recording. Use the S-VIDEO Output for high quality video output (see page 65).

S-VIDEO Inputs 3 and 4

Inputs 3 and 4 provide S-VIDEO (Super Video) jacks for connecting equipment with S-VIDEO output capability.

Component: Y-PBPRInputs

Inputs 1 and 2 provide Y-PBPRjacks for connecting equipment with this capability, such as a DVD player or Set Top Box. You may use composite video signal for both inputs.

NOTES: 1. Do not connect composite VIDEO and S-VIDEO to Input 3, 4 or 5 at the same time. S-VIDEO has priority over VIDEO input.

2.Your component outputs may be labeled Y, B-Y, and R-Y. In this case, connect the components B-Y output to the TV’s PB input and the components R-Y output to the TV’s PR input.

3.Your component outputs may be labeled Y-CBCR. In this case, connect the component CB output to the TV’s PB input and the component CR output to the TV’s PR input.

4.It may be necessary to adjust TINT to obtain optimum picture quality when using the Y-PBPRinputs (see page 38).

5.To ensure no copyright infringement, the MONITOR OUT output will be abnormal, when using the Y-PBPRjacks.

6.Input 1 and Input 2 (Y/VIDEO) can be used for composite video and component video input.