Hitachi 42V525 important safety instructions Connecting AN S-VIDEO Source to Input 3, 4

CONNECTING EXTERNAL VIDEO DEVICES

CONNECTING AN S-VIDEO SOURCE TO INPUT 3, 4 AND 5

1.Connect the cable from the S-VIDEO OUT of the VCR or the laserdisc player to the INPUT (S-VIDEO) jack, as shown on the TV set below.

2.Connect the cable from the AUDIO OUT R of the VCR or the laserdisc player to the INPUT (AUDIO/R) jack.

3.Connect the cable from the AUDIO OUT L of the VCR or the laserdisc player to the INPUT (AUDIO/L) jack.

4.Press the INPUTS button, then select INPUT 3 from the INPUTS menu to view the program from the VCR or laserdisc player. The VIDEO OSD label disappears automatically after approximately four seconds.

5.Select Antenna from the INPUTS menu to return to the previous channel.

	ANT A
TO
CONVERTER
						HDMI 1
	ANT B		INPUT 2	INPUT 1
			Y/	Y/
MONITOR OUT	INPUT 4	INPUT 3	VIDEO	VIDEO
S-VIDEO
				PB
			PR	PR
VIDEO
	(MONO)	(MONO)	(MONO)	(MONO)
L
AUDIO		TV AS CENTER				RS232C
						1	2	3	4	5
R							6	7	8	9
AUDIO
TO HI-FI
				R	L	V
						S-VIDEO
				VCR

FIRST TIME USE

NOTES: 1. Completely insert the connection cord plugs when connecting to rear panel jacks. The picture and sound that is played back will be abnormal if the connection is loose.

2.A single VCR can be used for VCR #1 and VCR #2 (see page 12), but note that a VCR cannot record its own video or line output. Refer to your VCR operating guide for more information on line input-output connections.

17