Mitsubishi Electronics WD-52526 System Reset Button, TV Reset Menu, Service, Support, Demo Mode

Page 72

72Appendices

Appendix G: Troubleshooting, continued

System Reset Button

If the TV does not respond to either the remote control or the front panel controls or will not power off, press the SYSTEM RESET button on the front panel with a pointed item such as the point of a ball point pen or end tip of a paperclip.

The TV will turn off and the green LED will flash quickly for about one minute. When the green LED stops flashing, you may turn on the TV again. The changes you made while the TV was most recently on, before you used the SYSTEM RESET button, may be lost; the changes you made previously, however, are not lost. Only those changes since the last power on may be lost when the system reset button is pressed. All other settings are retained.

TV Reset Menu

Select any device from the Device Selection menu.

Press TV MENU followed by 1,2,3 to open the RESET SERVICE MENU.

Read on-screen warnings before pro- ceeding, as some user data or settings may be erased.

Select Reset System Defaults (CAUTION: All settings except your V-Chip pass code will be reset to the original factory defaults).

Service

If you are unable to correct a problem with your TV, consult your Mitsubishi dealer or a Mitsubishi Authorized Warranty Service Center.

DO NOT adjust any controls other than those described in this Owner’s Guide.

DO NOT remove the protective back cover of your TV.

Menus not described and shown in this Owner’s Guide are designed for factory use and for authorized service personnel. Damage caused to the TV by unauthorized changes or changes to these menus made by unauthor- ized persons are not covered under warranty.

Support

To order replacement or additional remote controls, lamp cartridges, or Owner’s Guides, call 800-553- 7278.

For questions, call Consumer Relations at 800-332- 2119.

E-mail: MDEAservice@mdea.com

Website: www.mitsubishi-tv.com

Demo Mode

This TV has a demo mode for use in retail stores. To turn off demo mode:

1.Press TV MENU.

2.When the menu appears, press the following buttons in sequence:

0, QV, 0

Image 72
Contents WD-52526 WD-62526 For Your Records Model Number check one WD-52526 WD-62526Our Thanks Mitsubishi Digital Electronics America, IncContents Appendices Guidelines for Setting Up and Using Your New Widescreen TV First StepsSelection Menu ChannelView Channel GuideTV Care Appendix EAssistance Installation Notes Unauthorized SoftwareStand Requirement Lamp Replacement Dust-Filter CleaningOperating Notes Important Safeguards Important Safeguards Power LinesImportant Information About Your TV Chapter Special Features of Your TV Package ContentsReset TV Front PanelInput Front-Panel LED Indicators Lamp Indicator Lamp installation instructionsStatus Indicator POWER/TIMER IndicatorRemote Control OverviewRecord/Playback Keys Battery Installation Sleep TimerCare TV Back Panel ANT 1 AntennaInput 1 Component 1Service Port DVI Analog AudioHdmi 1 Digital Audio OutputPage Connecting Hdtv Cable Box or Satellite Receiver with Component Video Cable box or satellite receiver back panel to InputWall Outlet Cable Older Cable BoxAntenna with a Single Lead Antennas with Separate UHF and VHF LeadsFor an antenna with flat twin leads For cable or antenna with coaxial leadVCR and an Antenna or Wall Outlet Cable Audio & Video Optional Additional ConnectionsVCR and a Cable Box Audio and Video Direct Connections UUBDIPOMZPOFUZQF PGWJEFPDBCMFReceiver Stereo or Surround Sound Audio System DVD Player with Component VideoTo connect an analog A/V receiver Hdmi Device DVI DeviceTV Operation Choosing a Program Source Device Selection MenuChannelView Channel Listings Guide and DevicesDevice Section Video SectionOn-Screen Information Analog ProgramDigital Program Operation of PIP and POP PIP Device Selection Menu Selecting the PIP/POP DeviceSignal Definitions TV Display FormatsDVD Definitions Format DefinitionsPOBOBNPSQIJDPS4% Page TV Menu Operations Remote Control Buttons 3D Graphical Menu SystemMain Menu Setup Menu Setup MenuLanguage Memorize ChannelsTimer Lamp ReminderSoftware Version Input Name Menu Icon Order Menu Input Name MenuIcon Order Menu To change the icon orderChannel Menu Channel MenuSignal Strength Managing SQV Memory Banks Using the Remote ControlCaptions Menu Captions MenuBackground Opacity Setting a Pass Code Chip Lock MenuChip Lock Menu Overview Rating MenusOther Ratings Menu Rating systemBypassing V‑Chip Lock and Lock by Time V-CHIP KeyFront Button Lock Lock by TimeChip Signal Information Content CategoriesV-Chip Ratings Using the Audio or Video Button on the Remote Control Audio/Video MenuAudio/Video Menu Audio Settings Analog and Digital Audio SettingsDigital-Only Audio Settings Analog-Only Audio SettingsVideo Settings Page Appendix F Lamp Cartridge Replacement AppendicesPage Appendix a Bypassing the V-Chip Lock Bypassing the V-Chip LockDeactivating the Front Button Lock This page intentionally left blank Appendix B Remote Control Programming To Reset the Remote to Control TV Volume and MuteSpecial Programming for Use with an A/V Receiver ReceiversDVD Players Satellite Receivers/SAT/DTVVCRs Slide-Switch Position Affected Device Cable/DBS/DTVAudio Cable Boxes and Satellite ReceiversAppendix C Specifications Picture TechnologyReception InputsPhysical Characteristics and Power Consumption OutputsAppendix D General Cleaning CleaningGeneral Cleaning Warnings Top and Sides of the TVAppendix E Filter Cleaning Cleaning the Dust FilterAppendix F Lamp Cartridge Replacement Do not touch the glass parts of the lamp cartridge3FQMBDJOHUIF-BNQ$BSUSJEHF Appendix G Troubleshooting Symptom RemarksGeneral TV Operation LED Indicators PictureSound System Reset Button TV Reset MenuService Demo ModeTrademark and License Information Mitsubishi TV Software Mitsubishi LCD Rear Projection Television Limited Warranty To Obtain Warranty ServiceMitsubishi LCD Rear Projection Television Limited Warranty Index VCR Page MDEAservice@mdea.com Website Mail