■ ■ ■ ■
Trouble-Shooting
Red light does not blink | Replace batteries with 2 fresh, new |
when you press a key? | AAA/LRO3 alkaline batteries. |
|
|
The ONE FOR ALL | Make sure you are using new |
does not respond after | batteries and are aiming the |
pressing a key? | ONE FOR ALL at your device. |
|
|
The ONE FOR ALL does | A) Try all the codes listed for your brand |
not operate your | B) Try the search method on page 10. |
device(s)? |
|
|
|
Your brand is not listed | Try the search method on page 10. |
in the ONE FOR ALL |
|
code section? |
|
|
|
When following the set- | Did you use the Code Lock feature? |
up instructions, the red | You must first unlock the code before |
light on the ONE FOR ALL | entering a new code. Follow the |
only blinks once instead | instructions on page 19 to do this. |
of twice after you enter a |
|
| |
|
|
The ONE FOR ALL | You may be using the wrong code. |
is not preforming | Start the search method over |
commands properly? | again to locate the proper code. |
|
|
Press a key but get the | Hold MAGIC until the red light blinks |
wrong result? | twice, then press 992 and the device key |
| twice. You will need to |
| device again. Try the codes for brand |
| or the search method on page 10. |
You cannot control the | Hold MAGIC until red light blinks twice |
volume feature of your | Then press 993 and VOL+. To set the |
Satellite, Cable Con- | volume control back to TV (Punch- |
verter or TV/Video | Through), hold Magic until the red |
combination OR | light blinks twice, then press 993 TV. |
you cannot control the |
|
volume of the TV set |
|
up on the AUX key? |
|
|
|
Problems changing | Enter the programme number exactly |
channels? | as you would on your original remote. |
|
|
Video not recording? | As a safety feature on your ONE FOR |
| ALL, you must press the Record key |
| twice . |
|
|
Scan does not work on | Make sure your original remote had a |
your device? | programme +/- key. |
|
|
■ ■ ■ ■
20