Installation
The Search Method
If your Television, Video Recorder, Satellite Receiver or Cable Box does not respond to the ONE FOR ALL 4 after you have tried all the codes listed for your brand, try searching for your code. The Search Method may also work if your brand is not listed at all.
Let's say you cannot get your ONE FOR ALL 4 to control your Television.
To search for your TV code:
1
2
3
4
5
6
Switch your Television on.
Press the TV key on your ONE FOR ALL 4.
Aim the ONE FOR ALL 4 at your Television. Press and hold down MAGIC until the ONE FOR ALL 4’s red light blinks twice. Then, press 9 9 1. The red light will blink twice.
Now, alternate between TV and POWER, over and over, until your Television turns off. You may have to press these keys many times, so please be patient. Remember to keep pointing the ONE FOR ALL 4 at your Television when you press the POWER and TV keys.
When your Television turns off, press MAGIC. Don't forget, press MAGIC as soon as your Television turns off.
The ONE FOR ALL remote should now be ready to operate your device. Turn your device back on and try all the remote’s functions to ensure they are working properly. If some of the ONE FOR ALL’s commands are not operating correctly, try the search method again. You may be using the wrong code.
Important notes:
-To search for the code for your Video or Satellite follow the instructions above only press VCR or SAT during steps 2 and 4. To search for the code for your Cable Box, press SAT during step 2 and 4.
-If your Video's original remote control does not have a power key, press PLAY instead of POWER when searching for your code.
-During step 4, you may have to press these keys many times (up to 150!) so be patient. Remember you must aim the ONE FOR ALL at your device the entire time you are searching for your code.
8