One for All URC-7540 manual Installation, Direct Set-Up Setting Up Your Devices

Installation

Direct Set-Up

Setting Up Your Devices

To set up the ONE FOR ALL 4 for your TV, VCR, Satellite and Cable Box, follow the instructions below.

To set up your TV:

1			FOR				ALL
		ONE
		0009		0093,		0363,041
	Acura	0087,		0216
		0217,
	Admiral	0264
	Adyson	0516						0037,	0
	Agazi	0087 0009,
	AGB	0216,			0274			0371,
	Agef		0037,		0208,
	Aiko		0361,

Find your Television code in the Set-Up Code section (starting on page 11). Codes are listed by brand name. The most popular code is listed first. Make sure your Television is switched on.

2	Press and release your ONE FOR ALL 4’s
	TV key, then press and hold down the

MAGIC key until the red light blinks twice (the light will blink once then twice).

3

4

5

_ _ _ _

Enter your four-digit TV code using the number keys. The red light will blink twice.

Now, aim the ONE FOR ALL 4 at your Television and press POWER. If your Television switches off, your ONE FOR ALL 4 should be ready to run your Television.

Turn your device back on and try all the remote’s functions to ensure they are working properly. If the functions do not work properly, repeat steps 1-5 using another code listed under your brand.

Write your code in the four boxes provided in the battery compartment and on page 10 for easy future reference.

Important notes:

-To set up your Video Recorder or Satellite, follow the same instructions above, only press the VCR or SAT key during step 2.

-To set up your Cable Box, follow the instructions above only press the SAT key during step 2.

-Some codes are quite similar. If your device does not respond or is not functioning properly with one of the codes, try another code listed under your brand.

-If your Television, Video or Satellite does not respond, follow steps 1 through 5 with each code listed for your brand. If none of the codes listed for your brand operate your device, try the search method described on page 8, even if your brand is not listed at all.

-If you change programmes on your Television through your Video Recorder, press VCR and not TV, before you use the programme keys.

-Remember, to control your device after the ONE FOR ALL is set up, you must press the device key first (TV, VCR, SAT).

-Write the codes for your devices in the boxes provided on page 10 and in the battery compartment for easy future reference.

7