JVC HD-56FH97 manual Connecting to a Digital TV Receiver

Quick Setup

Connecting to a Digital TV Receiver

By connecting a Digital TV Receiver, high definition pictures can be displayed on your TV in their digital form.

TV Rear Panel

DIGITAL OUT

AUDIO OUT

L R

DTV Decoder

R-AUDIO-L

HDMI 1

1

DIGITAL-IN

2

HDMI to DVI Cable

After the connections have been made, tighten the screw to secure the cables.

1)Connect the HDMI to DVI Cable from the DIGITAL OUT on the back of your DTV decoder, to the HDMI1 DIGITAL-IN on the back of your television.

2)Connect a red cable from the "R AUDIO OUT" on the back of your DTV Device, to the HDMI 1 "R AUDIO" input terminal.

3)Connect a white cable from the "L AUDIO OUT" on the back of your DTV Device, to the HDMI 1 "L AUDIO" input terminal.

•The digital-in terminal is not compatible with the picture signal of a personal computer.

•Use a HDMI to DVI cable (commercially available) in order to digitally connect the television with a DTV decoder.

Notes:

•If 480p signals (640x480 or 720x480) are displayed on the screen, the horizontal balance may be slightly shifted. Access the “DIGITAL-IN” in the initial setup menu to adjust it. (Refer to page 55.)

•When you do the above connection, set DIGITAL-IN1 AUDIO in the Initial Setup menu to ANALOG. See "DIGITAL-IN1 AUDIO", page 55.

•The Analog Audio input can only be used with the HDMI 1 input.

•When setting the “DIGITAL AUDIO – ANALOG / DIGITAL” menu setting on the TV, please note that this setting only effects the HDMI 1 jack and that if you use a DVI to HDMI adapter this connection must be made to the HDMI 1 along with analog audio cables.

21

Downloaded from www.Manualslib.com manuals search engine