SW Main for firmware update (for technical support only)
DIP Switch Position |
|
| Pin#1 | Pin#2 | Pin#3 | Pin#4 | ||||||
|
|
|
|
|
|
|
|
|
|
|
| |
| Normal Operation Mode [via | OFF[ | ] | OFF[ | ] | OFF[ | ] | OFF[ | ] | |||
|
|
|
|
|
|
|
|
|
|
|
| |
| Normal Operation Mode [via USB port]7 | OFF[ | ] | OFF[ | ] | OFF[ | ] | ON[ | ] | |||
| Firmware | Update |
| Block A [main] | ON[ | ] | OFF[ | ] | OFF[ | ] | OFF[ | ] |
|
| Block B [remote] | ON[ | ] | OFF[ | ] | ON[ | ] | OFF[ | ] | ||
| Mode8 |
|
| |||||||||
|
|
| Block C [HDMI] | ON[ | ] | ON[ | ] | OFF[ | ] | OFF[ | ] | |
|
|
|
| |||||||||
Note
6.Factory default for SW Main is 
],
],
], & 
]. PLEASE MAINTAIN THIS SETTING AT ANYTIME FOR REGULAR USE VIA
7.Factory default for SW Main is 
],
],
], & pin#4- ON[
]. PLEASE MAINTAIN THIS SETTING AT ANYTIME FOR REGULAR USE VIA USB CONTROL!
8.Sequence for firmware update
WARNING! [Firmware update only can be done via
1.Power off the HSW88C. Execute the firmware
update program on your PC via COM1 port connection to the
2.Set the pin#1 of [SW Main] at ON[
] for firmware update mode.
3.Set pin#2 and pin#3 at respective positions to assign which Block to be updated.
4.Power on the HSW88C. The firmware update program should begin this update sequence automatically. If not, please check the
5.After the OK message shows up to indicate the firmware update sequence for designated Block is complete, please turn off the HSW88C.
6.Repeat step 3 ~ step6 if you want to update the firmware of the remaining Blocks.
7.Set the [SW Main] switch position to Normal Operation Mode.
8.Power on the HSW88C
IR CONTROL PATH
IR Sockets
HSW88C
IR Main: The default location for IR blaster to transmit all IR com- mand signals received from any of the eight remote receivers to all of teh HDMI sources.
IR
HSMR
IR Receiver: IR receiver connected here can receive all IR com- mand signals from the IR remote controls of HSW88C and all other HDMI source devices.