1 | 2 | 3 | 4 |
5 6
7
8
HARDWARE INSTALLATION
HSW88C as Master
1. | Connect all sources to HDMI Inputs on the 8x8 HDMI over |
| CAT5 matrix master HSW88C |
2. Connect each DDC output port on the HSW88C to respective | |
| DDC port on the remote receiver HSMR |
3. Connect each TMDS output port on the HSW88C to respective | |
| TMDS input on the remote receiver HSMR |
4. | Connect IR blaster to the IR MAIN jack of HSW88C and direct |
1.+5V DC: Spare power jack for over 60m transmission when the RX may need external power to work*.
2.TMDS: Plug in the CAT5 connected to the respective A/V SIGNAL port on the HSW88C
3.DDC: Plug in the CAT5 connected to the respective DDC port on the HSW88C
4.INPUT CHANNEL: Display the current selected HDMI source channel
5.INPUT SELECT: Push button for switching input source channel in sequential order
6.Signal Level
7.HDMI Output: Connect to HDTV with a HDMI cable
8.IR RECEIVER: Plug in IR receiver
The HSMR has been tested extensively and found that
it doesn’t require external power supply. If in rare situation you find it cannot work with the HSW88C, please use any +5V power adapter to plug in the power jack and see if it can work. If not, please contact your technical support for further service.
the IR blaster to the |
5. Connect the +5V 6A DC power supply to the HSW88C |
6. Power on all HDMI sources |
7. Power on the HSW88C |
HSMR as receiver
1.Connect each HDMI output to HDMI displays
2.Connect each DDC output port on the HSW88C to respective DDC port on the remote receiver HSMR
3.Connect each TMDS output port on the HSW88C to respective TMDS input on the remote receiver HSMR
4.Connect IR receiver and place the IR receiver at the appropriate position that can receive the IR command signals sent from the users
5.Dial the