Cable Electronics HSW88C instruction manual Specifications & Package Contents

Method C: Software Control Through RS-232 or USB

Software Control Menu

Input &
Source indicator	Output port

Status Indicator

1.Scan button:

Serial Port Scan:

Press Scan button, the computer will scan the all com port and display them.

Select the RS232 serial port connected to the Matrix switch. And set device ID 255 is for all device.

Only the same device id or 255 can get the command you send. Press OK. Get the new status from the Matrix switch (the port you select.)

SPECIFICATIONS & PACKAGE CONTENTS

	Model Name		HSW88C v1.3
	Technical		HSW88C		HSMR
	Role of usage		8x8 true matrix		Receiver [RX]
			Transmitter [TX]
	HDMI compliance		HDMI 1.3c
HDCP compliance				Yes
	Video bandwidth		[HSW88C v1.3] – Single-link 225MHz [6.75Gpbs]
Video support			480i / 480p / 720p / 1080i / 1080p60Hz
	Audio support		Surround sound (up to 7.1ch) or stereo digital audio
	HDMI over CAT5		Full HD (1080p) – 115ft (35m) [CAT5e] / 130ft (40m) [CAT6]
	transmission range		HD (720p/1080i) –165ft [CAT5e] / 180ft [CAT6]
	HDMI equalization		N/A		8-level digital rotary control
	TMDS signal		1.2 Volts [peak-to-peak]
	DDC signal		5 Volts [peak-to-peak, TTL]
		[1] Human body model — ±15kV [air-gap discharge] & ±8kV
	ESD protection	[contact discharge]
		[2] Core chipset — ±8kV
	PCB stack-up		4-layer board [impendence control — differential 100 ; single
		50 ]
			8x HDMI		1x RJ-45 [TMDS]
	Input		1x RS-232		1x RJ-45 [DDC]
			1xUSB		1x IR socket for IR receiver
			8x RJ-45 [TMDS]
	Output		8x RJ-45 [DDC]		1x HDMI
			9x IR socket for IR blaster
	HDMI Input selection		Push button / IR remote control /		Push button / IR remote
			RS-232/USB		control
	HDMI source control	Controllable via IR pass-through from IR receiver at RX to IR blaster
			at TX
	IR remote control	Electro-optical characteristics:		= 25° / Carrier frequency: 38kHz
	HDMI connector		Type A [19-pin female]
	RJ-45 connector		WE/SS 8P8C with 2 LED indicators [TMDS & DDC channels]
RS-232 connector			DE-9 [9-pin D-sub female]
	USB connector3		Standard type-B [square shape]
		Earphone jack for IR blaster
	3.5mm connector		[IR Main] IR control on all source		Earphone jack for IR receiver
			devices		[IR RECEIVER] Receives IR commands
			[IR PASS-THROUGH1~8] IR control on		from remote control
			individual source device
	DIP switch [HSW88C]	[SW1~SW8] 2-pin for EDID & audio mode
		[SW Main] 4-pin for operation & firmware update