3 Cisco 6130 NI-2 DSLAM System Cables | 78-10280-01 02/15/00 |
3.1 NEBS Compliance Cabling Guidelines
To comply with NEBS requirements, ensure that all cables are screw fastened onto backplane receptacles and that the cable Champ connectors are tie wrapped (Figure 3-1).
Figure 3-1 NEBS Cabling Compliance
Tie wrap
17092
screwconnector
3.2 Required Cables for Installation with POTS Splitter
During an installation with a POTS splitter, use only the Cisco cables specified in Table 3-1 to connect the Cisco 6130 NI-2 DSLAM, the POTS splitter, and the CO facility MDF. This section provides tables and illustrations for DSLAM-to-POTS splitter cable connections. Consult Siecor documentation for line connections from the MDF to the POTS splitter and POTS splitter cabling from the POTS splitter to the MDF.
Note Some Cisco 6130 NI-2 DSLAM receptacles in the cabling diagrams are not used because they are specific to one of the other Cisco 6100 DSLAM system configurations or because they are reserved for future use.
3.2.1 Making DSLAM-to-POTS Splitter Cable Connections
To connect the Cisco 6130 multiplexer chassis (MC) to the POTS splitter in installations with a POTS splitter, use one-to-one Cisco Champ cables. Use one-to-one cables to connect the POTS splitter xDSL outputs to the Cisco 6130 NI-2 multiplexer chassis ADSL inputs for DSLAM systems with quad-port DMT-2 ATUC-1-4DMT modules.
Table 3-2 lists the backplane connectors and part number for the Cisco one-to-one cable kit that permits you to connect the POTS splitter to the chassis (Cisco 6130 NI-2 DSLAM) backplane receptacles in installations with a POTS splitter.
3-2Cisco 6130 DSLAM with NI-2 User Guide