Cisco Systems 6130 appendix Required Cables for Installation without Pots Splitter

3 Cisco 6130 NI-2 DSLAM System Cables 78-10280-01 02/15/00

Figure 3-2 DSLAM to POTS Splitter Chassis Cabling Diagram (1-to-1 Cables)

			-48RTN	-48V B	-48RTN	-48V A	MODEM
	P14						POOL
							A
							OUT
	CRIT
	MAJ
	MIN
	FAN
	E2A
Cisco 6130
chassis	J42						J39
							P1
							P2
							P3
							P4
							P5
J43		J49					J40
		ANALOG TEST I/F
	J44	RING					J41
		TIP
		P18
	+	J1
Fan	P2
	FAN	-48VA	RTN	-48VB	RTN
tray	P2
		J1
POTS
splitter

28842

3.3 Required Cables for Installation without POTS Splitter

In an installation without a POTS splitter, use only designated cables to connect the Cisco 6130 NI-2 DSLAM and the CO facility MDF. The illustrations in this section show you how to connect three-to-three cables.

Note Some chassis connectors in the cabling diagrams are not used because they are specific to a different Cisco 6100 series NI-2 DSLAM system or because they are reserved for future use.

3.3.1 Using Three-to-Three Cables

To associate the CO facility MDF wire pairs and the DSLAM modem ports, the three-to-three cables remap wire pairs from the Cisco 6130 NI-2 DSLAM Champ connectors to the CO facility MDF Champ receptacles.

3-4Cisco 6130 DSLAM with NI-2 User Guide