Agilent Technologies N3280A manual TRIGgerACQuireSOURce, TRIGgerTRANsientSOURce, RST Value

6 – Language Dictionary

TRIGger:ACQuire:SOURce

This command selects the trigger source for the measurement trigger system.

EXT	External trigger input signal
BUS	GPIB device, *TRG, or <GET> (Group Execute Trigger)
	Command Syntax	TRIGger:ACQuire:SOURce <source>
	Parameters	BUS EXTernal
	*RST Value	BUS
	Examples	TRIG:ACQ:SOUR EXT
	Query Syntax	TRIGger:ACQuire:SOURce?
	Returned Parameters	<CRD>

TRIGger[:TRANsient]:SOURce

This command selects the trigger source for the output trigger system.

EXTernal	External trigger input signal
BUS	GPIB device, *TRG, or <GET> (Group Execute Trigger)
Command Syntax		TRIGger[:TRANsient]:SOURce <source>
	Parameters	BUS EXTernal
	*RST Value	BUS
	Examples	TRIG:SOUR EXT
	Query Syntax	TRIGger[:TRANsient]:SOURce?
Returned Parameters		<CRD>

TRIGger[:TRANsient]

This command generates an output trigger. Output triggers affect the following functions: voltage, current, and current limit. To program an output trigger you must specify a trigger level for the selected function, set the selected function to STEP mode, and initiate the trigger system.

Once these conditions are met, the output trigger will:

1.Initiate a pending level change as specified by [SOURce;]CURRent:TRIGgered, [SOURce;]CURRent:LIMit:TRIGgered, or [SOURce;]VOLTage:TRIGgered.

2.Clear the WTG bit in the Status Operation Condition register after both transient and acquire trigger sequences have completed. (WTG is the logical-or of both transient and acquire sequences.)

Command Syntax	TRIGger[:TRANsient][:IMMediate]
Parameters	None
Examples	TRIG	TRIG:IMM
Related Commands	ABOR INIT *TRG VOLT:TRIG CURR:TRIG
	CURR:LIM:TRIG	CURR:MODE CURR:LIM:MODE
	VOLT:MODE

74