Hardware Installation

1.Connect your HDMI/DVI source (such as a DVD player) to the transmit- ting unit AT-HDMI40S.

2.Connect your HDMI/DVI display (such as a plasma TV) to the receiving unit AT-HDMI40R.

3.Connect your CAT-5/5e/6 cable between the transmitting and receiving units.

4.Make sure your CAT-5/5e/6 cable is tightly connected and not loose.

5.Plug in 5V DC power cord to the power jack of the receiving unit.

6.Plug in 5V DC power cord to the power jack of the transmitting unit.

7.If a flickering or a blinking image is seen, try to adjust the rotational switch to improve the cable skew. 0 stands for the strongest EQ while 7 stands for the weakest. Try adjusting the EQ from 7 to 0.

NOTICE

1.If your HDMI/DVI device requires an EDID present, you can use an EDID Reader/Writer to provide DVI / HDMI EDID information.

2.All the transmission distances are measured using Belden CAT-5e 125MHz.

3.To reduce the interference among the unshielded twisted pairs of wires in CAT-5/5e/6 cable, you can use shielded CAT-5/5e/6 cables to improve EMI problems, which worsens in long transmissions.

4.Because the quality of the CAT-5/5e/6 cables has major effects in how long transmission distance will be, and the quality that is received by the display, the actual transmission length is subject to your CAT-5/5e/6 cables. For resolution greater than 1080i or 1280x1024, a CAT-6 is recommend- ed.