Motorola DCX3501-M quick start Cabling to DVR Storage

Page 10

Connecting Your Device

Cabling to DVR Storage

1.Contact your cable service provider to verify the set-top software necessary to support External DVR Storage is available in your area.

2.Connect the AC power cord to the external drive and plug the external drive’s AC power adapter into an electrical outlet.

3.Allow approximately 15 to 30 seconds for the external drive to reach operating speed.

4.Connect one end of the eSATA cable to the set-top.

5.Connect the other end of the eSATA cable to the external drive.

6.Follow the on-screen instructions.

DCX3501-M Quick Start Guide

9

Image 10

Contents DCX3501-M Introduction Additional information for adjusting user settingsBefore You Begin Standard-Definition TVFront Panel Rear PanelConnecting Your Device Cabling to an Hdtv for VideoCabling to an Hdtv for Audio Cabling to an Hdtv and an A/V Receiver for Video Cabling to an Hdtv and an A/V Receiver for Audio Cabling to a Standard-Definition TV Cabling to a Standard-Definition TV, A/V Receiver, and VCR Cabling to DVR Storage Set-top will not power on TroubleshootingThere is no audio when viewing cable channels Solution Then do one of the following There is no video on the TV screenThere are black bars to No closed captionsDisplay Right and leftConnecting the external drive to the set-top, does nothing There are black bars on all four sides of the pictureRecording Your Connections