Broan L250L, L200L, L300L, L100L, L150L warranty Read and Save These Instructions, Table of Contents

Page 1

 

MODELS

 

L100L • L150L • L200L • L250L • L300L

LOSONE SELECT®

Page 1

 

VENTILATORS

 

In-Line • 120V

 

READ AND SAVE THESE INSTRUCTIONS

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

1.Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty.

2.Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

3.Installation work and electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction codes and standards.

4.Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent backdrafting. Follow the heating equipment manufacturer’s guideline and safety standards such as those published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Con- ditioning Engineers (ASHRAE), and the local code authorities.

5.When cutting or drilling into wall or ceiling, do not damage elec- trical wiring and other hidden utilities.

6.Ducted fans must always be vented to the outdoors.

7.To reduce the risk of fire, use only metal ductwork.

8.If this unit is to be installed over a tub or shower, it must be marked as appropriate for the application and be connected to a GFCI (Ground Fault Interrupter) - protected branch circuit.

9.Never place a switch where it can be reached from a tub or shower.

10.This unit must be grounded.

TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

1.Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.

2.Always turn hood ON when cooking at high heat or when cooking flaming foods.

3.Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or filter.

4.Use proper pan size. Always use cookware appropriate for the size of the surface element.

TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:*

1.SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.

2.NEVER PICK UP A FLAMING PAN — You may be burned.

3.DO NOT USE WATER, including wet dishcloths or towels - violent steam explosion will result.

4.Use an extinguisher ONLY if:

A.You know you have a Class ABC extinguisher and you al- ready know how to operate it.

B.The fire is small and contained in the area where it started.

C.The fire department is being called.

D.You can fight the fire with your back to an exit.

* Based on “Kitchen Fire Safety Tips” published by NFPA.

CAUTION

1.For general ventilating use only. Do not use to exhaust hazard- ous or explosive materials and vapors.

2.To avoid motor bearing damage and noisy and/or unbalanced impellers, keep drywall spray, construction dust, etc. off power unit.

3.If ventilator is installed in an unconditioned space (such as an attic): Surround the ventilator with thermal insulation - to minimize possible condensation.

4.Please read specification label on product for further informa- tion and requirements.

TABLE OF CONTENTS

This manual is divided into sections as follows:

“TYPICAL INSTALLATION”

This section shows a common installation in new and existing, frame construction.

-Mounting (new construction)

-Mounting (existing construction)

-Wiring

-Ducting (straight through blower discharge)

“MOUNTING OPTIONS”

“WIRING OPTIONS”

-Wiring Plate Position

“DUCTING OPTIONS”

-Blower Discharge Positions

-Ducting (right angle blower discharge)

“USE AND CARE”

“SERVICE PARTS”

“WARRANTY”

Installer: Leave this manual with the homeowner.

Homeowner: Use and Care information on page 3.

Image 1
Contents Read and Save These Instructions Table of ContentsTypical Installation Mounting Options Ducting Options Wiring OptionsUSE and Care Ducting Right angle blower dischargeWarranty Service PartsAssembly BlowerAdvertencia LEA Y Conserve Estas InstruccionesCuidado ContendioInstalación Típica DEL ConectorConducto Tapa DEL TechoGarantia Piezas DE ServicioConjunto DELAvertissement Lire ET Conserver CES InstructionsTable DES Matières Montage Construction en cours Installation TypiqueCâblage Retirez la bande d’expédition de l’amortisseurOptions DE Câblage Options DE MontageUtilisation ET Entretien Garantie Pièces DE RechangeEnsemble DE Soufflerie