
Architect & Engineer Specification | AMERICAN DYNAMICS |
| |
| VIDEOEDGETM NETWORK VIDEO RECORDER |
| SABS (South Africa) Class B |
| CCC (China) Class B |
| MIC (Korea) Class B |
Safety | UL 60950 |
| CAN/CSA C22.2 No. 60950 |
| EN 60950 |
| IEC 60950 |
PART 3 – EXECUTION |
|
3.01EXAMINATION
A.Submission of a proposal confirms that the contract documents and site conditions are accepted without qualifications unless exceptions are specifically noted.
B.The site shall be visited on a regular basis to appraise ongoing progress of other trades and contractors, make allowances for all ongoing work, and coordinate the requirements of this contract in a timely manner.
C.The Network Video Recorder must be inspected before installation, and shall be free of any cosmetic defects or damage.
3.02PREPARATION
A.Prior to installation, the Network Video Recorder shall be configured and tested in accordance with the manufacturer’s instructions.
3.03INSTALLATION
A.The Network Video Recorder must be installed, programmed, and tested in accordance with the manufacturer’s instructions.
1.In order to ensure a complete, functional Network Video Recorder, for bidding purposes, where information is not available from the Owner upon request, the
2.Interfaces shall be coordinated with the Owner’s representative, where appropriate.
3.All necessary backboxes, racks, connectors, supports, conduit, cable, and wire must be furnished and installed to provide a complete and reliable Network Video Recorder installation. Exact location of all boxes, conduit, and wiring runs shall be presented to the Owner for approval in advance of any installation.
4.All conduit, cable, and wire shall be installed parallel and square with building lines, including raised floor areas. Conduit fill shall not exceed forty percent (40%). All wires shall be gathered and tied up to create an orderly installation.
VideoEdge® Network Video Recorder | 19 of 20 |