[Auto standby]
Turn on or off automatically standby.
[On] - Switch to standby 15 minutes of inactivity (for example, in pause or stop mode).
[Off] - Disable the auto standby mode.
[DivX(R) VOD Code]
Display the DivX® registration code.
Tip
8VHWKLVSURGXFW·V'LY;UHJLVWUDWLRQFRGHZKHQ\RXUHQW or purchase video from www.divx.com/vod. The DivX videos rented or purchased through the DivX® VOD (Video On Demand) service can be played only on the device to which it is registered.
Audio setup
1Press SETUP.
» [General Setup] menu is displayed.
2Press to select [Audio Setup], then press .
3Select an option, then press OK.
4Select a setting, then press OK.
To return to the previous menu, press . To exit the menu, press SETUP.
[Analogue Output]
Select an analogue setting based on the audio device that is connected through the analogue audio jack.
[Stereo] - For stereo output.
[LT/RT] - For surround sound output through two speakers.
[Digital Audio]
6HOHFWDGLJLWDOVHWWLQJEDVHGRQWKHGLJLWDODPSOLÀHU receiver that is connected through the digital jack (coaxial/digital).
[Digital Output] - Select a type of digital output.
[Off] - Disable digital output.
[All] - Support
[PCM Only] - Downmix to
30EN
[LPCM Output] - Select the LPCM (Linear Pulse Code Modulation) output sampling rate. [48kHz] - For discs recorded at sampling
rate of 48 kHz.
[96kHz] - For discs recorded at sampling rate of 96 kHz.
Note
[LPCM Output] setting is only available if the [Digital Output] is set to [PCM Only].
The higher the sampling rate, the better the sound quality.
[HDMI Audio]
Select the HDMI audio setting when you connect this product and the TV with an HDMI cable.
[On] - Allow audio output through the TV and the speaker system. If the audio format on the disc is not supported, it will be downmixed to
[Off] - Disable audio output from the TV. The sound is only output through the speaker system.
[Audio Sync]
Set the delay time for audio output when you play a video disc.
1.Press OK.
2.Press to set the volume.
3.Press OKWRFRQÀUPDQGH[LW
[Volume]
Set the default volume level when you play a disc.
1.Press OK.
2.Press to set the volume.
3.Press OKWRFRQÀUPDQGH[LW
[Sound Mode]
Select a preset sound effect to enhance the audio output.
[3D] - Select a virtual surround sound effect that is produced from the left and right audio channels.
[Movie Mode] - Select a sound effect for movies.
[Music Mode] - Select a sound effect for music.
[CD Upsampling]
For better sound quality in stereo mode, convert the music CD to a higher sampling rate.