Philips DVDR3435V/37 user manual RF output switch, Glossary, Select channel 3 on your TV

Page 100

100

RF output switch

 

 

 

 

 

 

 

 

 

 

You can watch the TV programs with the tuner of the unit. (Usually channel

 

 

 

 

 

 

 

 

 

 

3 or 4 of the TV is available for the RF converter setting.) Be sure to

2

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

connect the unit to a TV using the RF cable. Refer to page 14.

 

TV/ VIDEO

VCR

DVD

OPEN/CLOSE

 

 

 

1 Select channel 3 on your TV.

 

 

 

 

 

 

 

SEARCH

AUDIO

TITLE

RAPID PLAY

 

for more than

2

Press [TV/VIDEO] on the remote control.

 

 

 

3 seconds

 

 

 

 

 

 

 

 

 

 

• If noise appears, change the RF output channel of the unit to CH

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

4 by pressing [TV/VIDEO] for 3 seconds. The RF output channel

 

 

 

 

 

 

 

3 seconds

 

will alternate between CH3 and CH4 as follows.

 

 

(RF on) CH4

 

 

 

 

 

 

 

 

 

 

 

 

3 seconds

 

 

 

 

(RF on) CH3

 

 

 

 

 

 

 

 

 

 

 

 

3 seconds

 

 

 

 

(RF on) CH4

 

 

 

 

 

 

 

 

 

 

 

 

3 seconds

 

•

Each time the RF output channel is

 

 

changed, CH3 or CH4 will appear on

 

 

the front panel display.

Glossary

Analog audio

An electrical signal that directly represents sound. In contrast, digital audio which can be an electrical signal, but is an indirect representation of sound. See also Digital audio.

Aspect ratio

The width of a TV screen relative to its height. Conventional TVs are 4:3 (in other words, the screen is almost square); widescreen models are 16:9 (the screen is almost twice as wide as it is high).

Chapter

Just as a book is split up into several chapters, a title on a DVD disc is usually divided into chap- ters. See also Title.

Component video output

This is a video signal format that conveys each of three principal colors of light (red, blue and green) through different signal lines. This allows the viewers to experience picture colors as original as it is. There are several signal formats, including Y/PB/PR and Y/CB/CR.

Digital audio

An indirect representation of sound by numbers. During recording, the sound is measured at discrete intervals (44, 100 times a second for CD audio) by an analog-to-digital converter, generating a stream of numbers. On playback, a digital-to-analog converter generates an analog signal based on these numbers. See also Sampling frequency and Analog audio.

DivX®

DivX® is a codec (compression/decompression) that can compress images to a very small amount of data. The software can compress video data from almost any sources to the size that can

be sent on the Internet without compromising visual quality of the images.

Dolby Digital

The system developed by Dolby Laboratories to compress digital sound. It offers you sound of stereo(2ch) or multi-channel audio.

Finalize

To make recorded contents on DVD discs pos- sible to be played back on DVD players. With this unit, it is possible to finalize DVD+R/ DVD-RW/DVD-R discs.

JPEG (Joint Photographic Experts Group)

JPEG is a method of compressing still image files. You can copy JPEG files on CD-RW/R discs from a computer and play back the files on this unit.

MP3 (MPEG Audio Layer 3)

MP3 is a method of compressing files. You can copy MP3 files on CD-RW/R discs from the computer and play back the files on this unit.

PBC (Playback Control) (Video CD only)

This function enables you to play back interac- tive software using a menu screen. See also Video CD.

PCM (Pulse Code Modulation)

PCM is a format that converts audio into digital data. It is mainly used for Audio CDs and DAT. This unit can play back sounds as realistic as possible by converting even compressed Dolby Digital and MPEG audio to PCM.

Progressive Scan (525p/480p)

A type of display that does not split each frame into fields, and instead scans directly through all the scanlines of each frame in order. Progressive Scan provides less flickering and higher image resolution than traditional (525i/480i) TV signals. Refer to page 90 for instructions on selective Progressive Scan mode.

Regions code

Regions associate discs and players with par- ticular areas of the world. This unit will only play back discs that have compatible region codes. You can find the region code of your unit by looking at the rear panel. Some discs are compatible with more than one region (or all regions).

Sampling frequency

The rate which sound is measured by a specified interval to turn it into digital audio data. The numbers of sampling in one second defines as sampling frequency. The higher the rate, the bet- ter the sound quality is.

SAP (Secondary Audio Program)

Sub audio channel which is delivered separately from main-audio channel. This audio channel is used as an alternate in bilingual broadcasting.

S-Video output

It delivers independently each signal of color (C) and luminance (Y) to TV as video signals, so that higher-quality picture will be materialized.

Title (DVD only)

A collection of chapters on DVD disc. See also chapter.

Track

Audio CDs use tracks to divide the content of a disc. The DVD equivalent is called a chapter. See also Chapter.

VCR Plus+ system

Allows you to set a timer recording by entering a PlusCode number found in participating TV listings.

Video CD

The contents of a Video CD. When playing back a Video CD with the PBC function, the title menu will appear automatically.

Windows Media™ Audio

Windows Media™ Audio is the audio compress- ing technology developed by Microsoft. You can copy Windows Media™ Audio files on CD-RW/ R discs from a computer and play them back on this unit.

E9A90UD_EN.indb 100

6/12/2006 4:23:37 PM

Page 99 Page 101
Image 100
Page 99 Page 101
Contents Digital Video Disc Recorder Precautions Returning the enclosed card guarAntees that your date of purchase Entitled, including special moneyImportant Safety Instructions Precautions cont’dInstallation Location Avoid the Hazards of Electrical Shock and FireMoisture Condensation Warning About CopyrightMaintenance Dolby Digital RecordingTable of contents Features Functional overview Front PanelUnit can also be turned on by pressing these but- tons Rear PanelRemote Control Functional overview cont’dInstalling batteries in the remote control Using a remote controlVCR/DVD recorder switching Keep in mind the following when using the remote controlSetup menus Display menu Press DVD firstPress VCR first Press Display to display the On Screen displayFront Panel Display Guide Method Connection to a TVBasic Audio Good picture Method Better picture Connection to a TV cont’d Connection to a cable box or satellite boxTo set progressive scan mode, refer to To select channels of the cable box or satellite boxConnection to an Audio System AudioRemote Control Easy DVD recordingInstructions continue on the next Select the input to which the unit is connected on your TVEasy DVD recording cont’d Stop the recordingInitial setting Getting channels automatically Channel settingUnit will start getting channels available in your area Channel setting cont’d Press Setup Using K / L, select Channel. Press OKUsing K / L, select Manual Channel Preset. Press OK Adding/deleting channelsGuide channel setting Press Setup Using K / L, select ChannelUsing K / L, select Guide Channel Setting Press OK RememberUsing K / L, select a channel number. Press OK Selecting the TV stereo or SAP UsingStereoK / L, select Stereo or SAP. Press OKSAP Secondary Audio Program Setting the clock Auto Clock SettingSetting will be activated Auto Clock Setting function will be canceledSetting the clock cont’d Manual Clock SettingSetting the Daylight Saving Time Press Setup Using K / L, select Clock. Press OKSelecting the TV aspect ratio If you have a standard TVRecording mode Information on DVD recordingInformation Recordable discInformation on DVD recording cont’d DVD+R FinalizingSetting for Auto Chapter Using K / L, select on or OFF. Press OK Press Setup to exitBefore recording Replacing disc menuBasic recording PressPress DVD first Press OPEN/CLOSE a Press OPEN/CLOSE a to close the disc trayYou cannot pause a One-touch Timer Recording One-touch Timer RecordingRecording will start Timer Recording Timer Recording cont’d Timer Programming list will Each error number meansAppear Press Clear to erase the selected programHints for Timer Recording Priority of overlapped settingsTimer recording using VCR Plus+ system Using K / L, select a title to be overwritten. Press OK Turn on the unitOverwriting an existing title cont’d Overwriting in the middle of the titleHints for Overwriting Connection to an external source Settings for an external sourceVideo If you want to use SV input jack, select S-Video Settings for an external source cont’d Remote control, or Channel L / K on the front panelSelect a recording mode by pressing REC Mode Recording from an external sourceDV dubbing Guide to DV and On-Screen DisplayUsing K / L, then press OK Press Play B to find the point where you wish to beginDV dubbing cont’d DVC to DVD dubbingHints for DV dubbing DVC to VCR dubbingTo stop recording, press VCR then press Stop C Playing the discs in other DVD players Setting a disc to protectFinalizing a disc Playing the discs in other DVD players cont’d Finalizing is completedUsing K / L, select Disc Full or End of Timer Rec Auto finalizingUsing K / L, select Dubbing Mode. Press OK Dubbing ModeMake sure Dubbing Mode cont’d Using K / L, select VCR DVD. Press OKPress Setup to exit. Press DVD first Using K / L, select DVD VCR. Press OKInformation on DVD play Playable discsColor systems Region codesBasic playback Structure of disc contentsPlayback Basic playback cont’d Using K / L, select a desired title. Press OKPress Stop C to stop playback Press OPEN/CLOSE a to open the disc tray Press Play To start playbackPlaying MP3, Windows Media Audio, Jpeg disc When selecting the folderHints for MP3, Windows Media Audio and Jpeg files Playing back a DivX Basic playback contd HintsPlaying discs using the disc menu Playing discs using the title menuSpecial playback PauseResume play Press Play B to resume playSkipping TV commercials during play During playback, press FFW D or REW EDuring playback, press Commercial Skip Press Commercial Skip onceRapid play Special playback cont’dStep by step playback Using K / L, select a desired zoom factor to zoom. Press OK Using K / L / / B, select a desired zoom position. Press OKZoom During playback, press Pause F. Then press FFW D orMarker Setup Using / B, select Press OKMarker setup menu will appear LaterUsing Prev or Next Using DisplaySearch Title/Chapter searchTrack search Search cont’dTime search Repeat playback Program playback Repeat/Random/Program playback/Slide Show cont’dSlide Show DivX VOD DivXDivX Subtitle Switching audio soundtrack Switching subtitlesSelecting the format of audio and video Switching virtual surround system Selecting the format of audio and video cont’dVirtual Surround menu will appear Select Virtual Surround OFF in a case sound is distortedSwitching camera angles Your setting will be activatedDuring playback, press DISPLAY. Display menu will appear Menu will appearEditing discs Setup menu Information on disc editingGuide to a title list Editing discsUsing K / L, select Edit. Press OK. Edit menu will appear Editing discsDeleting titles Press DVD first Press TitleEditing discs contd Using K/ L, select Title Delete. Press OKTitle list will appear Example DVD+RW/DVD-RW Editing discs cont’d Putting names on titlesFollow steps 1 to 3 on page 73 to display the Edit menu Character setSetting chapter marks Press Play B and then Pause F to decide the pointAt which you will create a new chapter mark It is convenient to use Prev or Next , REW EClearing chapter marks Using K / L, select Current Chapter. Press OK Using Prev or Next , Play B and Pause FUsing K / L, select Hidden. Press OK Editing discs cont’d Hiding chaptersSetting pictures for thumbnails Dividing a title You can divide one title into two new titlesAt which you will divide the title FFW D for finding the point to be dividedEditing discs Setup menu Using K / L, select Edit Disc Name. Press OKPutting name on disc Example DVD-RWSetting or releasing disc protect Editing discs Setup menu cont’dSetting disc to protect Press DVD first Editing discs Setup menu cont’d83 Erasing discMaking edits compatible Tour of the Setup menu Setup Items highlight is the default ContentsLanguage setting Language setting cont’d Display settingDisplay setting cont’d Audio settingWhen playing disc with copyright protection Audio setting cont’dDynamic Range Control Default on Video setting Progressive Scan Default OFFUsing K / L, select Still Mode. Press OK Using K / L, select a setting. Press OKSettings for Parental lock level Using K / L, select Parental Lock. Press OKUsing K / L, select the desired level. Press OK Parental Lock Default AllSettings for Parental lock level cont’d Settings for PBC Playback ControlPlayback RecordingRecording and One-touch Timer Recording cont’d One-touch Timer RecordingOther operations Index searchTroubleshooting SET Troubleshooting cont’d Not work Recording Error Parental Lock On100 RF output switch Press TV/VIDEO on the remote controlGlossary Select channel 3 on your TVLanguage code Language CodeFrequently Asked Questions SpecificationsLimited Warranty This Limited Warranty does not coverMeet Philips at the Internet 8239 300
Top Page Image Contents