Philips PDCC-ZYL-0906 user manual Basic Operations, Switching the system on/off, Volume control

Basic Operations

English

IMPORTANT!

ÐBefore you operate the system, complete the connection procedures.

ÐWhen the system is switched to Standby mode, it is still consuming power.To disconnect the system from the power supply completely, reomve the AC power plug from the wall socket.

Switching the system on/off

●In standby/Eco-power standby mode, press STANDBY-ONBor SOURCE on the set, or DISC, USB, FM or AUX on the remote to switch on the system.

➜ The system will switch to the selected or last selected source.

To switch the system to standby mode

●In power-on mode, press briefly STANDBY- ONB (B on the remote).

➜ The clock time will be displayed. Or "--:--" will be displayed if clock time is not set.

To switch the system to Eco-power standby mode

●In power-on mode, press and hold STANDBY- ONB (B on the remote).

➜“ECO POWER” is displayed briefly.

➜Eco-power lamp B on the front panel will light up.

➜The LCD display will go blank.

Helpful hints:

–Pressing and holding B on the remote can switch between Eco-power standby and normal standby.

Power saving automatic standby

As a power-saving feature, the system will automatically switch to Standby mode if you don’t press any button within 15 minutes in the stop mode.

Volume control

Press VOLUME (or VOL +/- on the remote) to increase or decrease the volume level.

➜The display briefly shows ”VOL” and a volume value from “01” to “31” ( “MIN” or “MAX” is displayed when adjusted to the lowest or highest volume level).

To switch off the volume temporarily

●Press MUTE on the remote.

➜ Playback will continue without sound and “MUTE” appears.

●To activate sound reproduction, you can:

– press MUTE again;

– adjust the volume controls;

– change source.

Sound Control

DBB (Dynamic Bass Boost)

DBB enhances the bass response.

●Press breifly LOUD/DBB to enable or disable DBB feature.

➜ If DBB is activated, “DBB” will be shown.

Helpful hints:

–Some discs might be recorded in high modulation, which causes a distortion at high volume. If this occurs, switch off DBB or reduce the volume.

DSC (Digital Sound Control)

DSC provides a different type of preset sound equalizer setting.

●Press DSC on the remote (or on the system) repeatedly to select:

POP(default), CLASSIC, ROCK, JAZZ.

LOUDNESS

LOUDNESS feature enables the system to automatically increase the treble and bass sound effect at low volume (the higher the volume, the lower the treble and bass increase).

●Press and hold LOUD/DBB on the remote control to enable/disable LOUDNESS feature.

➜ icon appears/disappears after this feature is enabled/disabled.

20