Connections (continued)
E n g l i s h
FM
ANT
AM
ANT
ANT IN
2
INT IN TO TV VIDEO | AUDIO IN | |
IN | R | L |
CH3 CH4
3
1
|
|
| VIDEO OUT | ||
VIDEO OUT |
|
| |||
|
|
| PB | PR | DIGITAL IN |
|
|
|
|
| |
Y | PB | PR | DIGITAL IN |
|
|
|
|
|
|
| |
|
|
|
|
| VIDEO |
L |
|
| VIDEO |
|
|
R |
|
| N | TO AV SUBWOOFER | |
|
|
| |||
TO AV SUBWOOFER |
|
|
IMPORTANT!
The progressive scan video quality is only possible when using Y Pb Pr and a progressive scan TV is required.
Option 3: Using Component (Y Pb Pr) Video jack
1Use the component video cables (red/ blue/green - not supplied) to connect the DVD system’s Y Pb Pr jacks to the corresponding component video input jacks (or labeled as Y Pb/Cb Pr/Cr or YUV) on the TV.
2To hear the TV channels through this DVD system, use the audio cables (white/ red - supplied) to connect the DVD system’s TV IN jacks to the audio input jacks on the TV.
3Proceed to page 20 for detailed Progressive Scan set up.
IMPORTANT!
If your TV only has a single Antenna In jack (labelled as 75 ohm or RF In), you will need an RF modulator in order to view DVD playback on the TV. See your electronics retailer or contact Philips for details on RF modulator availability and operations.
Using an accessory RF modulator
1Use the supplied composite video cable (yellow) to connect the DVD system’s CVBS jack to the video input jack on the RF modulator.
2Use an RF coaxial cable (not supplied) to connect ANTENNA OUT or TO TV jack on the RF modulator to the ANTENNA IN jack on the TV.
3Connect the Antenna or Cable TV service signal to the ANTENNA IN or RF IN jack on the RF modulator. (It may have been connected to your TV previously. Disconnect it from the TV).
12
12 | 05/04/05,31394:16 PM246 14793 |