Set up a network, Use Philips EasyLink | Philips BDP2700 specification

	Video	Menu Language
	Video
	Audio	Audio
	Audio	Subtitle
		Subtitle
	Network	Disc Menu
	EasyLink	Parental Control
	EasyLink
	Preference	Screen Saver
	Preference	Auto Subtitle Shift
		Auto Subtitle Shift
	Advanced	Change Password

•The language options may vary from different regions.

4Press to select a language, and press OK.

Set up a network

To enjoy software updates of this player and BD- Live for certain Blu-ray discs, set up the network connection.

Note

•Ensure that the network cable is properly connected and the router is switched on.

1 Connect this player to the broadband modem or router.

2Press to display the home menu.

3Select [Setup] and press OK.

Video	Network Installation

View Network Settings

Audio

Network

EasyLink

Preference

Advanced

4Select [Network], and press .

5Select [Network Installation], and press OK.

6Follow the on-screen instructions to complete the network installation.

»Once connected, an IP address is obtained automatically.

Tip

•You can check the status of the wired connection of this player (see “Adjust settings” > “Network Setup” > [View Network Settings]).

Note

•Loading BD-Live content from the internet may take some time, depending on the ﬁle size and the speed of the internet connection.

Use Philips EasyLink

This player supports Philips EasyLink which uses the HDMI CEC (Consumer Electronics Control) protocol. You can use one single remote control to control EasyLink-compliant devices that are connected through HDMI connectors.

Note

•To enable the EasyLink feature, you must turn on the HDMI CEC operations on the TV and on other devices connected to TV. Refer to the TVs/devices manual for details.

One-touch play

1Press (standby) to turn on this player.

»TheTV (if theTV supports one-touch play) automatically turns on and switches to the correct video-in channel.

»If a disc is loaded, disc play automatically starts.

One-touch standby

1Press and hold (standby) for more than 3 seconds.

»All the connected devices (if the device supports one-touch standby) automatically switch to standby.

Note

•Philips does not guarantee interoperability with other HDMI CEC devices.

12EN