2Insert one lithium CR2025 battery with correct polarity
3Close the battery compartment.
Note
•Before you press any function button on the remote control, first select the correct source with the remote control instead of the main unit.
•If you are not going to use the remote control for a long time, remove the battery.
Turn on
1Press 
.
»The unit switches to the last selected source.
Switch to standby mode
1Press and hold 
for over 3 seconds to switch the unit to Eco Power Standby mode.
»The backlight on the display panel turns off.
»The blue Eco Power indicator turns on.
To switch the unit to standby mode:
1In Eco Power Standby mode, press and hold 
for over 3 seconds.
»The clock (if set) appears on the display panel.
»The blue Eco Power indicator turns off.
Store radio stations automatically
If no radio stations are stored, the unit can store radio stations automatically.
1Turn on the unit.
2Press SOURCE repeatedly until [TUNER] is displayed.
»[AUTO INSTALL 
to start the automatic installation) is displayed.
3 Press | . |
| |
» The unit automatically stores radio | English | ||
stations with sufficient signal strength. | |||
| |||
» After all available radio stations are stored, the first stored radio station is broadcast automatically.
Set clock
1In standby mode, press and hold CLOCK for over 2 seconds to activate the clock setting mode.
»[SET CLOCK] scrolls on the display, and then [24H MODE]
2Press VOL +/- to select [24H MODE] or [12H MODE]
» The hour digits begin to blink.
3Press VOL +/- to set the hour.
4Press CLOCK to confirm.
» The minute digits begin to blink.
5Press VOL +/- to set the minute.
6Press CLOCK to confirm.
Adjust brightness of display panel
1In standby mode, press MODE/DIM repeatedly to select different brightness levels.
Find the correct viewing channel
1 Press
to turn on the unit.
2Press DISC to switch to disc mode.
3Turn on the TV and switch to the correct
EN 13