2Getting started
2.1Inserting the batteries
• Insert 2 AAA type batteries, noting the + and - configuration in the battery compartment.
Note
When replacing the batteries, all user settings will be retained in the remote control memory for 5 minutes.
2.2Testing the universal remote control
It is advised to test whether your device(s) already respond(s) to the SRP2004WM before setting it up (see chapter 2.3).The example below instructs you how to do this for your TV. You can repeat the same steps for other devices (DVD player/recorder, Cable/Satellite box and VCR) which you want to operate using the SRP2004WM.
Example: testing the universal remote control | |
on your TV: | |
1 | Switch ON your TV manually or use the |
| original remote control for this. Tune to |
2 | channel 1. |
Press the | |
| device selection key |
| to select TV. |
| • The red Setup |
| light lights up. |
• | If the light does not |
| light up, check whether the batteries are |
| properly inserted (see chapter 2.1). |
4EN
WM_17__Manual_80_210.indd 4 |