3Look up the 4-digit
| code for your brand |
|
| in the brand list at |
|
| the back of this user |
|
| manual. |
|
| A |
|
| shown for each brand. | |
| Use the digit |
|
| buttons to enter the |
|
| code for your brand. |
|
| • If the red Setup |
|
| light turns off, |
|
| an invalid code |
|
4 | was entered. In this case, try again. | |
Aim the remote | 5 - 60 sec. | |
| control at the TV. |
|
Press and hold the 
button. Release it immediately as soon as the TV switches off.
•This step normally takes between 5 and 60 seconds. In extreme circumstances
this step can take up to 15 minutes. 5 Switch ON the TV. 
Try out the buttons 
that you need for 
operating it.Try, for 
example, if the
- CH + and digit
buttons function properly.
• If a button does not work as expected, press and hold that button. Release it immediately as soon as it works. For more information, see chapter 2.2.2.
6 Press the 
device selection |
| |
button twice to |
| |
finish setup. | 2 x | |
• When no | ||
| ||
button is |
| |
pressed for 5 minutes or more, the | ||
remote control will exit setup mode, automatically saving all your settings.
Important
If you made a mistake:
•Press the device selection button twice to exit setup.The red Setup light 
turns off.
•Restart from the beginning.
•If the device does not respond at all or not to all of the button commands or if you cannot find the code for your brand, enter ‘9, 9, 9, 9’ in step 3 and continue with step 4.The remote control will now search its full database for a code that works with your TV. Full database search may take up to 15 minutes.
2.2.1 Setting up the remote controls for other devices (DVD player / recorder, DTV, Cable / Satellite box, DVR and VCR)
1 Make sure the device is switched on and operational. E.g. insert a disc in the DVD player / recorder or a video cassette in the VCR (SRP2006 only).
2Then follow steps 2 to 6 of ‘Setting up the universal remote controls to operate your TV’. Make sure to use the correct device selection button:
-for SRP2003: 
or 
.
-for SRP2006: 
, 
, 
, 
or 
.
2.2.2Improving buttons
When correctly set up, the remote control should be able to operate all your devices. However, when using the remote control for the first time it might occur that some buttons do not yet function as expected.
In this case you can have the remote control search for alternatives.
Note
Improving buttons is not possible when the code was found during full database search (with code ‘9, 9, 9, 9’).
Getting started English
6 | EN | EN | 7 |