Scosche Industries HDJ-2450 manual Matching the Beats Per Minute BPM, Program play, Loop Play

OPERATIONS

11. Matching the Beats Per Minute (BPM)

There are three tools available for matching the BPM of the two CDs:

•Use the pitch slider to adjust the BPM satirically.

‚Use the PITCH BEND buttons to change the BPM temporarily. ƒ Turn the JOG dial to change the BPM temporarily.

1)Pitch Slider

ŒTo adjust the BPM by sliding the pitch slider up or down, press the PITCH button to turn on the PITCH adjustment

function before useing.

•Slide the pitch slider up to decrease BPM, or down to increase BPM. The adjustment range is +/-8,+/-12,+/-16%.

2)Pitch Bending

lThe BPM increases or decreases	by the Pitch slider when you let go to the PITCH BEND+ or -.
respectively while the PITCH BEND+ or	lFigure 11 shows an example of how to use the pitch bend function.
PITCH BEND- button is pressed.	In this example, both players are playing and the BPM has already
lThe BPM increase depends on how long	been matched with the pitch sliders.

you hold the button. If you hold the button	The bass beats also match
for about 1/2 second, theBPM will go either

to +16% for PITCH BEND+ or -16% for	CD1	Bass beat
PITCH BEND-. If you tap the button, the	bass beat
BPM will only change a little so you can	CD2		PITCH BEND
change the beat slightly without audible
changes in the music.	bass beat
lThe CD will return to the tempo indicated		Bass beat	Figure 11-1

3)Turn the JOG dial

Turn the jog dial clockwise during play to increase the BMP in the forward direction, counterclockwise to decrease the BMP in the reverse direction. The faster you turn the wheel, the more the BMP changes. The BMP changes with a range of +/-8,+/-12,+/-16%.

When you release jog wheel, the CD will return to the tempo indicated by the pitch slider.

12. Program play

ŒPress the PROGRAM button, the player will enter the program mode and the CD will stop rotating.

•Select the desired track by pressing the SKIP button, then press the PROGRAM button again. The selected track will be added to the program sequence.

Ž Repeat step 2 operation. A maximum of 20 tracks can be programmed at one time.

• Press the PLAY/PAUSE button to start the program play from the first selection.

• Press the program button again during program play to stop play.

‘ Press and hold the program button more than 2 secords to cancel the program mode and erase all the current program contents.

13.Loop Play

ŒPress the LOOP button to set the loop start point A, the LOOP indicator will flashes on the LCD.

•Press the LOOP button again to set the loop end point B, after the B point is set, the playback will enter the loop

play from A to B repeatedly.

ŽPress the LOOP button again, the loop play function is canceled, the LOOP indicator goes out.

14.Relay Play

Press PROG and SGL button to switch relay function; the indicator on the LCD track display when flash when relay is on.

15. Fader start

You have the possibility to start the respective CD-player directly from the mixer. Make sure that the Control socket is connected with the respective socket on the mixer. Additionally, the Audio out socket have to be connected with the Line-input sockets of your mixer. Please note that the Fader start function only works with the appropriate mixers. Insert the CD and select the desired track. Start playback from your mixer.