Making a recording
1Press MONITOR to display the selected input signal on the screen.
2Select the program number from which the recording is to be carried out using CHANNEL q or CHANNEL r .
Recording via the external jacks
Select either the front jack ('', '') or the jack ('EXT1', 'EXT2',') |
| ||||
at the back of the recorder, from which the recording is to be carried |
| ||||
out, using CHANNEL q or | CHANNEL r . |
| |||
Selecting the recording mode (quality) |
| ||||
You can select between 'M1' (camcorder recordings/1 hour), 'M2' (2 |
| ||||
hours), 'M2x' (2,5 hours), 'M3' (3 hours), 'M4' (4 hours) or 'M6' (6 |
| ||||
hours) using REC MODE . |
|
| |||
SAFE RECORD |
|
|
|
|
|
Usually, a recording starts at the point where the previous recording |
| ||||
ended. This will delete all subsequent recordings. |
| ||||
If a new recording is to be | placed at the end of all recordings, hold | Tip | |||
down REC/OTR | n | until ' |
| ||
|
| ' appears on the display. |
| ||
3Press RECORD or REC/OTR n to start the recording.
a' ' (no signal) will appear on the display |
|
b Check whether the cable jacks fit correctly. |
|
b If the recording is made from a video recorder, adjust the 'tracking' |
|
setting on the video recorder. |
|
b In case of bad, | Problem |
may not be able to detect the signal. |
Programming recordings
1Press TIMER s on the remote control.
2Select line 'Timer Programming' using B or A and confirm with C .
The current data will be displayed.
3Select the entry field with D or C .
4Enter the desired data with B , A or the number buttons 0..9 .
5Confirm with OK .
The data was stored in a TIMER block.
6 | To end, press TIMER s . |
Timer
Timer Programming
Rec
Date Ch. Start End Mode
01/22 01 08:30AM 10:00PM M1
To store | |
Press SELECT | Press OK |
7Switch off the DVD Recorder with STANDBY m .
A programmed recording will only function if the DVD Recorder is switched off using STANDBY m .