Philips 29PT9111/01 manual Preparation, Surround Sound loudspeakers

Page 3

Installation

Preparation

Place the TV on a solid surface.

For ventilation, leave a space of at least 5 cm free all around the set.

To prevent any fault and unsafe situations, please do not place any objects on top of the set.

Insert the aerial plug tightly into the aerial socket g at the back of the TV with an aerial cable of good quality.

CABLE

English

4Check if the loudspeaker switch at the back of the TV is in the l position.

Surround Sound loudspeakers

4Connect the two Surround Sound rear loudspeakers supplied to the connector clips at the back of the TV. Always connect both Surround Sound loudspeakers.

4Connect the left rear loudspeaker at REAR L and the right rear loudspeaker at REAR R at the back of the set.

4Push the connector clip down and insert the end of the wire into the opening : the positive wire (the one with the black line) to the red loudspeaker connection; the negative wire to the black loudspeaker connection. Do not insert the wires too far.

8	mm

R

L

REAR

FRONT

The Surround Sound loudspeakers should always be located behind or to either side of the listener. If preferred you can also hang the loudspeakers on the wall.

Insert the mains plug in the wall socket with a mains voltage of 220V-240V.

3

Image 3

Contents Contents Your remote control Video recorderPicture In Picture Surround Sound loudspeakers PreparationRemote control Switch TV onSelect the menu language Select CountryPress OK Store TV channels Automatic installationManual installation Press Menu Installation menu reappears Go on toSearch for a TV channel Manual installationPress Menu Enter the programme numberEnd Direct selection of a TV channelReshuffle the programme list Enter or modify a programme nameSelect Favourite TV channels Install TV ConfigurationExt. Amplifier Yes Surround ModeCentre Mode Normal or Wide External amplifierProgramme lights up Keep the Menu key pressed to switch off all menusFast exit from the menus Select Programme with the keys V or WSwitch menus on and off Switch TV onSwitch to standby Adjust the volumeSharpness Select the picture settingsAdjust picture settings Main MenuDynamic Contrast TintSelect the sound styles with the sound menu Select the sound settingsAdjust sound settings Select Graphic Equalizer with the keys V or W and press OKSelect Spatial sound Select the sound modeSwitch Loudness on or off Select SpeechDolby* Pro Logic Install Surround Mode lights upMarked with Dolby Surround Local menu adjustments disappear VolumeChild Lock FeaturesSleeptimer Pip SizeMessage Press OK when you have entered the complete messageStart Time lights up TimersRecording Source Select Programme listInformation on screen Other functionsVertical Squeeze Bilingual broadcastClock Adjust BrightnessPermanent Programme Number Select previous programmePP key Open the door of the remote control Press MPhoto Finish Mosaic screenScan Select a TV channel with the digit keysPip Picture in Picture Switch pip on and offOpen the door of the remote control Press p Press p again to switch pip offSelect Pip size Switch screensSelect Still Picture Move the pip screenSelect a Teletext Switch Teletext on and offTeletext About the Easy Text systemQuickly run through the teletext pages Select subpagesSelect the index teletext Select Special teletext functions Select Continuous SubtitlesSearch for and store the test signal of the video recorder Connect Peripheral EquipmentTV and video recorder Headphone TV and a CD-i/Photo CDAudio equipment Camera and camcorderConnect a decoder without an aerial socket to the TV Extra loudspeakersDecoder Connect a decoder with an aerial socket to the TVTVB Record with your video recorder Keep Menu pressed for a short while to switch off each menuOperate the video recorder with the TV remote control End of life directives TipsIndex Favourite programmes, 10 features Freeze, 25 frequency