Philips TS3258, TS3658 manual Using the Smart Lock Block Channel Control, Press the Channel + or

After your personal access code has been set (see previous

page), you are now ready to select up to 5 channels or inputs to block out or censor.

BEGIN

Note: You can also block out the use of the A/V external inputs on the rear of the TV. This stops the viewing of VCR, DVD, etc., programs which can be shown through the A/V Input jacks. Select AV 1, AV 2, or SVID-R, MM1, MM2, MM3, and select block.

Press the MENU button on the remote to show the on-screen menu. PICTURE will be highlighted.

Press the CURSOR DOWN ■ button twice to select the FEA- TURES menu.

Press the CURSOR RIGHT

▶▶button and the menu will

shift to the left, then CURSOR DOWN ■ to highlight the SMART LOCK control.

Press the CURSOR RIGHT

▶▶button again to shift the dis- play left, the BLOCK CHANNEL control will be highlighted.

Press the CURSOR RIGHT

▶▶button. “---- Enter current access code” will appear within the menu.

Enter the correct access code number. “XXXX” shows on the

SETUP CODE display as you press the NUMBER buttons. “XXXX Code correct” will appear.

Press the CHANNEL (+) or

(–)buttons (or NUMBER but- tons) to select the channel you want to block.

Press the CURSOR RIGHT

Any channel that has been blocked will be skipped when the Channel (+) and

(–)buttons are used to scan all available channels. To view a blocked channel, press the number buttons on the remote to directly access the channel and refer to the Unblocking Channels section below.

▶▶button to block viewing of the channel, or the CURSOR LEFT ◀◀ button to allow viewing of the channel.

Repeat steps 5 through 7 for any other channels you wish to block from viewing.

UNBLOCKING CHANNELS

Access the blocked channel direct- ly by using the number buttons on

the remote control.

Enter your four digit access code.

All blocked channels will be view- able until the TV is turned off. When

the TV is turned back on, the blocked channels will not be viewable.