Philips CDR775 S General Information, Set complies with the FCC-Rules, Part 15 and with 21 CFR

Page 3

GENERAL INFORMATION

CAUTION

USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

The set complies with the FCC-Rules, Part 15 and with 21 CFR 1040.1

CDN Canada

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications.

Cet appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables dans la règlement sur le brouillage radioélectriques édicté par le ministère des communications du Canada.

CAUTION

TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERTED.

ATTENTION

POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPON- DANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

LASER

Type

Semiconductor laser GaAlAs

Wave lenght

775-795 nm (at 25°C)

Output Power

2,5 mW (Read)

 

35 mW (Write)

Beam divergence

60 degree

This warning label is located on the rearside and inside this laser product.

CAUTION: INVISIBLE LASER RADIATION

WHEN OPEN. DO NOT STARE INTO BEAM DANGER: INVISIBLE LASER RADIATION WHEN OPEN.

AVOID DIRECT EXPOSURE TO BEAM.

VARO! AVATTAESSA JA SUOJALUKITUS OHITEJTAESSA OLET ALTTIINANAKYMATTOMAALLE LASERSATEILYLLE.ALA KATSO SATEESEEN.

OSYNLIG LASERSTRÅLNING NÄR DENNA DEL ÄR ÖPPNAD VARNING!OCH SPARREN AR URKOPPLAD. BETRAKTA EJ STRALEN

or

DANGER - Invisible laser radiation when open.

AVOID DIRECT EXPOSURE TO BEAM

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC (U.S.A.) RULES.

OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS : (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

NOTE

This equipment has been tested and found to comply with

If this equipment does cause harmful interference to radio

the limits for a Class B digital device, pursuant to part 15

or television reception, which can be determined by

of the FCC Rules. These limits are designed to provide

turning this equipment off and on, the user is encouraged

reasonable protection against harmful interference in a

to try to correct the interference by one or more of the

residential installation. This equipment generates, uses and

following measures :

can be used in accordance with the instructions, may

- reorient or relocate the receiving antenna.

cause harmful interference to radio communications.

- increase the separation between the equipment and

However, there is no guarantee that interference will not

receiver.

occur in a particular installation.

- connect the equipment into an outlet on a circuit

 

different from that to which the receiver is connected.

 

- consult the dealer or an experienced radio/TV technician

 

for help.

IMPORTANT

THIS PRODUCT WAS FCC VERIFIED UNDER TEST CONDITIONS THAT INCLUDED USE OF SHIELDED CABLES AND CONNECTORS BEWTEEN SYSTEM COMPONENTS. IT IS IMPORTANT THAT YOU USE SHIELDED CABLES TO REDUCE THE POSSIBILITY OF CAUSING INTERFERENCE TO RADIOS, TELEVISION SETS AND OTHER ELECTRONIC DEVICES.

IF YOU HAVE ANY PROBLEMS CONTACT YOUR DEALER.

ANY CHANGE OR MODIFICATIONS TO THE EQUIPMENT BY THE USER NOT EXPRESSLY APPROVED BY THE GRANTEE OR MANUFACTURER COULD VOID THE USER’S AUTHORITY TO OPERATE SUCH EQUIPMENT.

Image 3
Contents CDR775 Important Safety Instructions Set complies with the FCC-Rules, Part 15 and with 21 CFR General InformationCD-R Player Limited WarrantyEspañol Français English ContentsEnglish Table of Contents Audio Technical dataAbout this manual GeneralDiscs for playback Discs for recording Maintenance EnglishAccessories General Information and DiscsCD recorder Operating Buttons and ConnectionsOperating buttons on the front EnglishOperating Buttons and Connections Display Connections at the backDisplay indications Display messages Display Installation Menu messages See Menu modeConnections general Analog connections CD player deck Use the digital coaxial cable supplied InstallationPower supply Inserting batteries in the remote control Setup recommendationsPress ON/OFF CD recorder will switch on Number/alphabet keys 0 Remote ControlRemote control commands Inserting discsFor recording from external sources RecordingRemarks about recording Recording modes For recording from internal CD-deckStart high speed recording Preparing for high speed recordingListen mode recording from internal CD player Preparing for Listen mode recordingStart Listen mode recording Start recording Manual recording from external CD playerPreparing for manual recording Stop the sourceIf you wish to record a complete disc or program Preparing for autostart recordingPlaying Finalizing CDR & Cdrw discsUnfinalizing Cdrw discs Erasing Cdrw discs To erase one or more tracks from the endTo erase the entire disc Playing CDs on Deck 1 and/or Deck 2 DJ mode Play a 2-disc changer Changer modeSearch Selecting a track when CD play is stoppedHold down 5 or 6 in play mode Selecting a trackOnly in Changer mode Shuffle random order playRepeat CD, track or program Clearing a program ProgrammingRemarks about programming Programming for playbackPress Easy JOG/ENTER to confirm selections Menu ModeRemarks about Menu mode General operation of MenuMenu MODE/CD Text English Text input/text editErasing text/text erase Reviewing CD Text in memory/memory view Menu MODE/RECORDING Settings Balance only active in Record/Standby modeEnglish Auto track increment/auto track Fixing Problems English 3104 125