7 Other Information
Troubleshooting
Unorderly ripples on the picture
Most problems you encounter with your TV can be corrected by consulting the following troubleshooting list.
No picture, no sound
1.Check if the fuse or circuit breaker is working.
2.Plug another electrical device into the outlet to make sure it is working or turned on.
3.Power plug is in a bad contact with the outlet.
4.Check the signal source.
It is usually caused by local interference, such as cars, daylight lamps and hair driers. Adjust the antenna to minimize the interference.
Blank screen in VGA mode
Perhaps the TV can not recognize the resolution set by the PC. Suggest to change to the best resolution or other standard resolutions of the Windows system.
No color
1.Change the color system.
2.Adjust the saturation.
3.Try another channel.
Remote control does not work
1.Change the batteries.
2.Batteries are not installed correctly.
3.Main power is not connected.
No picture, normal sound
1.Adjust the brightness and contrast.
2.Broadcasting failure may happen.
Normal picture, no sound
1.Press the Vol+ button to increase volume.
2.Volume is set to mute, press the mute button to restore sound.
3.Change the sound system.
4.Broadcasting failure may happen.
Snowy dots and interference
If the antenna is located in the fringe area of a television signal where the signal is weak, the picture may be marred by dots. When the signal is extremely weak, it may be necessary to install a special antenna to improve the reception.
1.Adjust the position and orientation of the indoor/outdoor antenna.
2.Check the connection of antenna.
3.Fine tune the channel.
4.Try another channel. Broadcasting failure may happen.
Ignition
Black spots or horizontal streaks appear, or the picture flutters or drifts. This is usually caused by interference from car ignition system, neon lamps, electric drills, or other electrical appliance.
Ghost
Ghosts are caused by the television signal following two paths. One is the direct path, the other is reflected from tall buildings, hills, or other objects. Changing the direction or position of the antenna may improve the reception.
Radio frequency interference
This interference produces moving ripples or diagonal streaks, and in some case, loss of contrast in the picture. Find out and remove the radio interference source.
16 EN