Switching on and initial setup

Before you switch on the TV, check that the AC power cord is properly connected. Press .POWER at the right side of the TV, or press

.(standby-On) on the remote control.The TV normally takes 25-30 seconds to start up and the following screen appears the ﬁrst time you turn on the TV.

After you read a welcome screen, follow the on-screen instructions to select your language and complete your TV setup. Installation takes approximately 20 minutes.

	Select your menu	● English
	language with the	● English
	Up/Down buttons on	● Français
	your remote control,	● Français
	press the OK button to	● Español
	proceed.	● Español

Press Î/ ï to select the desired mode for energy saving, then press OK.

	Location Home is recommended	Retail store


	for normal home use. In the
	for normal home use. In the
	Retail Store location all settings	Home
	are fixed.	Home

Select [Retail store] if you want backlight to be brighter. Select [Home] to reduce power consumption.

You must set [Home]. Otherwise, personalized picture and sound settings will not be memorized after the unit goes to standby mode.

•Select [Retail store], the unit will be set up with predeﬁned setting for retail displays. In this setting, the power consumption may possibly exceed the limited requirement of the ENERGY STAR® qualiﬁcation.

•Select [Home], the unit will be set to maximize energy efﬁciency. Picture and sound settings can be adjusted and saved as per your personal preferences.

Press Í/Æ to select [Start], then press OK to begin [Settings assistant].

Settings assistant will allow you to customize your picture settings to your personal preference. You will see a series of test pictures where the right side and left side differ. Select the side that is most pleasing to you with the Left/Right buttons.

Cancel Start

Select [Picture A] or [Picture B] by pressing Í/Æ that is the most pleasing to you, then press OK.You see 5 different pictures to be completed.

Which side of the picture do you prefer?

Cancel

Picture A

Picture B

Press Í/Æ to select [Store], then press OK.

Store your preferences.

Cancel Store

Press OK to ﬁnish [Settings assistant].

The TV has learned your preferences.

Exit

Press Í/Æ to select [Finish], then press OK.

Finish the Setup.

Note

•If you are not receiving a signal from your cable service, contact the CATV provider.

•If you press . during autoprogram, an installation will be canceled except the language selection.

•The initial autoprogram function can be executed for either [Antenna] or [Cable] only once.When you change the connection (Antenna / Cable), set autoprogram again. (Refer to page 34.)

English

EN 11