DOD FX7 owner manual Editing Programs

signal processing

BANK

1 2 or 3

Editing Programs

DATA

Delay

11-19 Mono 100ms

21-29 Mono 200ms

31-39 Mono 250ms

41-49 Mono 300ms

51-59 Mono 350ms

61-69 Mono 400ms

71-79 Mono 500ms

DATA

1)After you power up, the FX7 defaults to Program mode. Select a Bank by pressing the Bank selector footswitch. The display shows the selected bank number on the left side of the display and a dash on the right. The display might look something like this:

2-_

2)Press footswitch 1, 2, or 3. The dash in the display changes to show the number of the Program you selected. The display might look something like this:

23

NOTE: If a new Program number is not selected within 5 seconds after pressing the Bank select button, the display returns to its pre- vious setting.

As you become more familiar with the FX7, you may find that you need to modify certain Programs to better fit your needs. Fortunately, the FX7 is flexible enough to give you everything you need without being difficult to program.

The following procedure is an example of how to modify your Programs. Suppose that Program 33 (which has a 100 ms mono delay, a medium chorus, noise gate, EQ, distortion, and compression) sounds close to what you want, but you want a 300 ms delay with low feedback instead. Here's how to change it:

1)Use the Data wheel, or the Bank and Program selector footswitches to select Program 33.

2)Press the Delay effect group button. The Delay group Status LED begins flashing and the display reads:

11

3)Look at the front panel Delay groupings to locate the effect you want. In this case, you'll see that the 300 ms mono delays can be found between 41 and 49 in the Delay (not Multi-Delay)

Group.

4)Use the Data wheel to scroll until the the display reads:

41.

FX7 owner's manual 9