DOD FX7 owner manual Safety Instructions European

Page 2

C A U T I O N

RISK OF ELECTRIC SHOCK

DO NOT OPEN

A T T E N T I O N : RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR

W A R N I N G : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE

The symbols shown at left are internationally accepted symbols that warn of potential hazards with electrical products. The lightning flash with arrowpoint in an equilateral triangle means that there are dangerous voltages present within the unit. The exclamation point in an equilateral triangle indicates that it is nec- essary for the user to refer to the owner’s manual.

These symbols warn that there are no user serviceable parts inside the unit. Do not open the unit. Do not attempt to service the unit yourself. Refer all ser- vicing to qualified personnel. Opening the chassis for any reason will void the manufacturer’s warranty. Do not get the unit wet. If liquid is spilled on the unit, shut it off immediately and take it to a dealer for service. Disconnect the unit during storms to prevent damage.

U.K. MAINS PLUG WARNING

A moulded mains plug that has been cut off from the cord is unsafe. Discard the mains plug at a suitable disposal facility. NEVER UNDER ANY CIRCUM-

STANCES SHOULD YOU INSERT A DAMAGED OR CUT MAINS PLUG INTO A 13 AMP POWER SOCKET. Do not use the mains plug without the fuse cover in place. Replacement fuse covers can be obtained from your local retailer.

Replacement fuses are 13 amps and MUST be ASTA approved to BS1362.

SAFETY INSTRUCTIONS (EUROPEAN)

NOTICE FOR CUSTOMERS IF YOUR UNIT IS EQUIPPED WITH A POWER CORD.

WARNING: THIS APPLIANCE MUST BE EARTHED.

The cores in the mains lead are coloured in accordance with the following code:

GREEN and YELLOW - Earth

BLUE - Neutral

BROWN - Live

As colours of the cores in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as fol- lows:

•The core which is coloured green and yellow must be connected to the terminal in the plug marked with the letter E, or with the earth symbol, or coloured green, or green and yellow.

•The core which is coloured blue must be connected to the terminal marked N or coloured black.

•The core which is coloured brown must be connected to the terminal marked L or coloured red.

The power cord is terminated in a CEE7/7 plug (Continental Europe). The green/yellow wire is connected directly to the unit's chassis. If you need to change the plug, and if you are qualified to do so, refer to the table below.

CONDUCTOR

WIRE COLOR

Normal

Alt

 

 

L

LIVE

BROWN

BLACK

 

 

 

 

N

NEUTRAL

BLUE

WHITE

 

 

 

 

E

EARTH GND

GREEN/YEL

GREEN

 

 

 

 

WARNING: If the ground is defeated, certain fault conditions in the unit or in the system to which it is connected can result in full line voltage between chassis and earth ground. Severe injury or death can then result if the chassis and earth ground are touched simultaneously.

IMPORTANT!

FOR YOUR PROTECTION, PLEASE READ THE FOLLOWING:

WATER AND MOISTURE: Appliance should not be used near water (e.g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc). Care should be taken so that objects do not fall and liq- uids are not spilled into the enclosure through openings.

POWER SOURCES: The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance.

GROUNDING OR POLARIZATION: Precautions should be taken so that the grounding or polarization means of an appliance is not defeated.

POWER CORD PROTECTION: Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance.

SERVICING: The user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel.

FUSING: If your unit is equipped with a fuse receptacle, replace with only same type fuse. Refer to replacement text on the unit for correct fuse type.

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Guitar Effects PROCESSOR/PREAMP Safety Instructions European Signal processing Introduction About the Pictorial Guide IndicatorsWarranty Signal processing Supplying Power Getting StartedEffect Selector Buttons Digital FX- This row of but Program and Bank Selector FOOTSWITCHES- TheseFront Panel Controls Effect Selector Buttons Preamp This row of fourRear Panel Connections Do not Apply Power to the FX7 Until Instructed Hooking UpProgramming the FX7 Navigating The FX7 Using The FootswitchesTo select Programs using the footswitches To select Programs in the FX7Editing Programs To store a Program into a memory location Storing ProgramsBypassing To bypass individual effectsTo bypass the selected Program Using a Controller With The FX7Word About Mono Operation About the FX7s Effects EqualizersMono Delays Specifications Factory Program ListFX7 Block Diagram FX7 is a registered trademark of DOD Electronics Corporation

FX7 specifications

The DOD FX7 is a versatile and innovative guitar effects pedal that has made a significant impact in both live performances and studio recordings. Launched as part of the DOD series, the FX7 is known for its user-friendly interface and a wide array of tonal possibilities, making it a favorite among genre-spanning musicians.

One of the standout features of the FX7 is its extensive collection of effects. The pedal includes nine different effects settings, ranging from classic distortion and overdrive to lush chorus and vivid flanger. This enables guitarists to achieve a diverse palette of sounds suitable for various musical styles, from rock to blues to jazz.

The FX7 utilizes an advanced digital signal processing (DSP) technology that ensures high-quality sound reproduction and low noise levels. This technology allows musicians to incorporate complex effects without deteriorating the original tone of the instrument. Additionally, the FX7’s analog circuitry complements its digital components, enriching the overall sound and providing warmth that many players seek.

Ease of use is another defining characteristic of the DOD FX7. The pedal features a straightforward layout with clearly labeled knobs for adjusting the level, tone, and effect parameters. This allows musicians to make quick adjustments during performances, ensuring they can switch between settings seamlessly without interrupting the flow of their music.

Moreover, the FX7 offers a robust build quality, designed to withstand the rigors of touring and frequent use. The pedal's durable casing protects the internal components from physical damage, while the footswitch is engineered for responsive engagement, allowing for reliable performance under pressure.

Another notable technology embedded in the FX7 is its true bypass circuitry. This feature ensures that when the pedal is not engaged, the guitar signal remains unaltered, preserving the natural tone of the instrument without adding unwanted noise or coloration.

In summary, the DOD FX7 is a dynamic and feature-rich effects pedal that stands out in the competitive world of guitar effects. Its combination of diverse effects, advanced technology, ease of use, and rugged design makes it a crucial tool for both amateur and professional musicians seeking to expand their sonic horizons. Whether on stage or in the studio, the FX7 proves to be a reliable partner in creativity.
Top Page Image Contents