Tips
No power | • Check the TV’s AC power cord is plugged into the mains socket. If there |
| is still no power, disconnect plug. Wait for 60 seconds and |
| Switch on the TV again. |
|
|
Poor reception | • The proximity of mountains or high buildings may be responsible for |
| ghost pictures, echoing or shadows. In this case, try manually adjusting |
| your picture: refer to “Fine Tune” on page 9 or modify the orientation |
| of the outside aerial. If you are using an indoor aerial, reception may be |
| difficult in certain conditions.You can improve reception by rotating the |
| aerial. If the reception remains poor, you will need to use an external aerial. |
|
|
No picture | • Check the antenna connection at the rear of the TV. |
| • Try another programme to confirm whether it is a particular TV station |
| problem or otherwise. |
|
|
Good picture but no | • Try increasing the volume. |
sound | • Check that the sound is not muted. If it is muted, press the Mute button |
| on the remote control to restore sound. |
|
|
Good sound but poor | • Try increasing the contrast and brightness setting. |
colour or no picture |
|
|
|
Snowish picture and | • Check antenna connection at the rear of the TV. |
noise |
|
|
|
Horizontal dotted | • Possible electrical interference e.g. hairdryer, vacuum cleaner, etc. Switch |
line | off appliances. |
|
|
Double images or | • Possible poor positioning of antenna. Using a highly directional antenna |
“Ghost” images | may improve reception. |
|
|
TV not responding | • Aim remote control handset directly at remote control sensor lens on |
to remote control | the TV. |
handset | • If there is no response, check whether plastic insulation sheet is removed |
| and the battery is placed correctly (words on battery should be facing you). |
| • Try changing the battery. |
| • If the set receives no signal for 15 mins, it automatically goes into standby |
| mode. |
|
|
Incorrect Display | • Adjust the image position using the Horizontal Position and/or Vertical |
position (PC mode) | Position in the PC Mains Controls menu. |
|
|
No Video Input (PC | • Make sure the monitor cable is properly connected to the PC input |
Mode) | (VGA/DVI) at the bottom of the TV. |
| • Check whether the monitor cable has bent pins. |
|
|
Vertical flicker | • Try eliminating the vertical bars by using the Clock Adjustment of Video |
appears (PC Mode) | Noise in the Main PC Menu. |
|
|
Horizontal flicker | • Try eliminating the horizontal bars by using the Phase. Adjustment of |
appears (PC Mode) | Video Noise in the Main PC Menu. |
|
|
Screen too bright or | • Try adjusting the contrast and brightness in the Main Menu. |
dark (PC Mode) |
|
|
|
19