Test reception

This menu allows you to check the strengh of the signal you are receiving through your aerial.

&From the digital mode, press the

button to display the setup menu.

éUse the œ button to select installation and pressÉ button to display the installation menu.

“Use œ button to select Test reception and press Ébutton. You obtain an indication of

the actual programme frequency, the network name, the signal quality and strength.

‘You now have to enter the frequency of the digital channel you want to test.

Your TV magazine can provide the list of digital

channel numbers. Use the table on page 30 to get the frequency.

(If the signal quality and strength is poor, a message appears at the bottom of the menu prompting you to enter the frequency between the lower and the higher limit. If after keying the frequency, the reception is still poor, you can try improving, renewing, adjusting or updating the aerial. It is however advisable to contact a specialised aerial installer in order to achieve best results.

Language and location preferences

This menu allows you to select your preferred language for audio, subtitle, teletext and menu and make changes to the location (country and time zone).

&From the digital mode, press the button

to display the setup menu.

éUse the œ button to select preferences and press É button.

“Use œ button to select Languages, Location or Digital Audio Output and press Ébutton.

‘Use the o or œ button to select a setting and press É button to enter into the sub-menu.

Make your adjustment and press OK button or

pbutton to exit.

Language default settings

•Audio : to select the audio sound language.

•Subtitle/Teletext : No function (not applicable).

•Subtitling mode : No function (not applicable).

•Subtitles for hearing impaired : No function (not applicable).

•System : to select the menu language.

Location settings

•Country : to select the country where you are located.

•Time zone : to select the time zone where you are located.

Digital Audio Output settings

To select AC3 (if the amplifier supports the Dolby Digital format) or PCM (if it doesn’t support Dolby Digital format).

NOTE : If you select AC3 sound, you must have your TV conected to a Home Theatre System or amplifier. In this mode, no sound will be heard from the TV speakers directly.

(Press the button to leave the menu.