Connect Peripheral Equipment
There is a wide range of audio and video equipment that can be connected to your TV. The following connection diagrams show you how to connect them.
Note: EXT1 can handle CVBS and RGB; EXT2 CVBS, Y/C and RGB; EXT3 CVBS; DVI can handle VGA, SVGA, XGA (only 50PF9966) and 480p, 576p, 720p (only 50PF9966), 1080i and 1152i.
It is preferable to connect peripherals with RGB output to EXT1 or EXT2 as RGB provides a better picture quality.
Note: If your recorder is provided with the EasyLink function, it should be connected to EXT2 to benefit from the EasyLink functionality.
Recorder (VCR-DVD+RW)
Note: Do not place your recorder too close to the screen as some recorders may be susceptible to signals from the display. Keep a minimum distance of 0,5 m from the screen.
CABLE
Connect the aerial cables 1, 2 and, to obtain the optimum picture quality, eurocable 3 as shown.
If your recorder does not have a euroconnector, the only possible connection is via the aerial cable.You will
1
2
EXT2
3
4
therefore need to tune in your recorder’s test signal and assign it programme number 0 or store the test signal under a programme number between 90 and 99, see Manual installation, p. 6.
See the handbook of your recorder.
Decoder and Recorder
Connect a eurocable 4 to your decoder and to the
RECORDER
DECODERspecial euroconnector of your recorder. See also the recorder handbook. See Decoder, p. 10. You can also connect your decoder directly to EXT1 or 2 with a eurocable.
Other equipment (satellite receiver, decoder, DVD, games, etc.)
CABLECABLE
EXTERNAL
1 | 4 | 3 | 5 |
| 2 | ||
|
|
|
&Connect the aerial cables 1, 2 and 3 as shown (only if your peripheral has TV aerial
éLook for the test signal of your peripheral in the same way as you do for a recorder.
“ Make a selection in the Setup, Source menu, p. 10.
RECORDER
19