Audio- and video equipment keys

AMP DVD/R TV SAT AUX

†

v Select

Ò ‡ π

æb

SMENU

+ +

V ¬ P

- -

1 2 3

4 5 6

This system remote control operates the following Philips equipment:TV,VCR, DVD, DVD/R, SAT (RC5/RC6), AMP (+TUNER), CD, CD/R.

Press the Select key to operate any of the equipment indicated in the display

(AUX = CD; DVD/R = DVD, SAT = SAT (RC5). Another device can be selected by pressing Select repeatedly within 2 seconds. The led will blink slowly to indicate the device.

Press one of the keys on the remote control to operate the peripheral equipment. To return to TV mode press Select while the led is blinking.

When no action is taken within 60 seconds, the remote goes back to TV mode.

When you do not want the remote to go back to TV mode, and to stay in the mode selected, proceed as follows:

Select the desired mode with the Select key. Wait until no LED is lit. Press the Select key again simultaneously with the OK key for at least 2 seconds. The remote will not go back to TV mode from now on and will remain in the mode selected. To go back to the default setting of the remote (TV mode) repeat what is explained above, selecting the TV mode.

Note: When the Select key is pressed and held for more than 2 seconds, the RC5/RC6 system select command is transmitted.

7 8 9

i 0 0

Active Control

b h q

ON/OFF Ambilight MODE

Bto switch to standby

ºæ for pause (VCR, DVD, CD) RDS news/TA (AMP);

to shuffle play (CD/R)

®for record

Òfor rewind (VCR, CD); search down (DVD, AMP)

‡for stop

πfor play

†for fast forward (VCR, CD); search up (DVD, AMP)

Sfor pause (CD/R)

bRDS display (AMP);

to select your choice of subtitle language (DVD);

idisplay information

MENU to switch the menu on or off

-P + for chapter, channel, track selection

0 to 9 digit entry

0tape index (VCR),

select a DVD title/chapter, select a frequency (AMP)

UVCR timer

cursor up/down

to select the next or the previous disc (CD)

cursor left/right

to select the previous or following track (CD) search up/down (AMP)

Additionally the DVD/R, SAT and AUX indicator can be programmed to operate the DVD-R, DVD + receiver, DVD-R + receiver, SAT (RC6), CD-R and VCR instead.

&Select TV with the Select key.

éTo program

•DVD-R, press the OK key + digit 2;

•SAT (RC6), press the OK key + digit 4;

•CD-R, press the OK key + digit 6;

•DVD + receiver, press the OK key + digit 7;

•DVD-R + receiver, press the OK key + digit 8;

•VCR, press the OK key + digit 9.

“Select the corresponding DVD/R, SAT, AUX indicator. The remote control will operate your DVD-R, DVD or DVD-R in combination with a receiver (DVD/R), SAT (RC6) (SAT), CD-R or VCR (AUX).

Note: To return to the modes programmed in the factory, either remove the batteries for a few minutes, or press the OK key + digit 1 (DVD mode); or + digit 3 (SAT-RC5) or + digit 5 (CD mode).