LCD TV Quick Use Guide
Thank you for purchasing this Philips LCD Television set. You are now the proud owner of a LCD TV set which promises full value to you as
a customer. Before you proceed to install the LCD TV, please follow the steps and diagrams as shown to familiarise yourself with the correct and safe way of assembling the stand to the TV.
|
| ASSEMBLING THE STAND |
|
|
|
1 | 2 | |
|
| ! |
|
| |
Ensure you have the following before you assemble the stand :
– Two screws (supplied with set)
– One Screwdriver (not supplied)
Open back plate cover by gently pulling upwards.
Place the set facing down on a protective sheet close to the edge of a flat surface.
3 | Bottom of swivel base | 4 |
1
2
Align arrow to the center
For swivelling of the stand to function properly, adjust the swivel base at the back of the stand until arrow is aligned in the center. Align the stand studs into the holes at the bottom of the set. Put in the screws (provided) into the 2 holes and tightened with a screwdriver.
Close back plate cover by gently pushing the cover downwards.
Check the stand arm is rigid and properly installed. Place the set upright.
CAUTION : While putting in the screws, hold onto the stand.
INSTALLING LCD TV ON THE WALL
If you intend to install the LCD TV on the wall. ensure you have the following :
– Standard VESA 100 bracket for LCD TV (not supplied) and four spacers found in the accessory bag.
Do the following when installing the LCD TV on the wall :
1
Ñ
2
Ñ
VESA Bracket does not fit
3
Spacer x 4
Tighten
VESA bracket to spacers
Ñ 
If your VESA bracket does not fit into the slot at the rear of the LCD TV, proceed to make use of the four spacers provided. Note : If VESA bracket fits into the slot, you need not use the spacers.
Screw the four spacers to the holes at the rear of the set. Ensure the spacers are properly tightened (torque of
Place the VESA bracket on the spacers and tightened with the VESA bracket screws.