Dometic RM182B service manual Removal and Installation of Refrigerator

C . REMOVAL AND INSTALLATION OF REFRIGERATOR

Remova 1

1.Disconnect electrical supply. And make sure the gas supply is shut off at its source.

2.Remove the vent /air-intake assembly on the van wall outside .

a.Unscrew three self-tapping screws (A,Fig.2) of the windscreen (B,Fig.2) then remove windscreen and separating plate (C, Fig. 2).

b.Unscrew four screws (D,Fig.2) of the fixing plate (E,Fig. 2) and remove fixing plate and gasket (F, Fig. 2) from the caravan wall (G, Fig. 2) to the vent casing (H,Fig. 2).

3.Open and remove all three doors of the kitchen cabinet (Fig.3). Pull out dra- wer. Dismantle and remove shelves. Then lift door from hinge posts (Fig.3).

4.Remove three protective caps (A, Fig.4) from the refrigerator frame (B,Fig.4) and unscrew the three screws that are behind the caps. Then on each side through the doors, unscrew two phillips screws (C, Fig.4) from the walls of the refrigerator.

5.pull refrigerator frame forward in the lower right (Fig. 5,arrow A) Ft en pull out the left groove according to arrow (B,Fig.S) toward the right.

6.Remove 120 V connection plug (A, Fig.6) from the socket, pull out 12 V plug connection (B, Fig.6).

Unscrew threaded union of the gas-connection line (C,Fig.6) of the refrige- rator.

7.Unscrew ventilation grill (A. Fig. 7) by removing two screws (B, Fig. 7) and then remove refrigerator by pulling forward.

Installation

The installation is carried out in the reverse sequence to that described for the removal of the refrigerator.

IMPORTANT:

After installation, check gas system for leaks, with soapy water.

NEVER USE A MATCH

-5-