D.COMPONENT REPLACEMENT RM182B
NOTE:
For the removal of gas and electrical components and of the refrigerator cooling unit, the refrigerator must be removed from the kitchen cabinet (see chapter C) .
1.Replacing the electric heater
_____
1.Squeeze the heater insulation in direction of arrow (A,Fig. 8) until it clicks open. Pull open the insulation in direction of arrow ( B,Fig. 8) and remove it .
2.Unscrew fixing screw (C, Fig. 8) of the heater and remove the heater from its pocket by pulling straight up.
3.Unscrew the two screws of the cover (F, Fig. 9) exposing the terminal block.
4.Unscrew the heater cable at the terminal block and remove heater with cable.
5.To replace heater, reverse the procedure.
NOTE :
The heater has a groove (D, Fig. 8) at the bottom, into which the fi-
xing screw fits. Place the new heater inside | the heater tube so that | |||
the | groove is | in the correct position for the | fixing | screw. The bottom |
of the heater | should be level with the bottom | of the | heater tube. | |
2. Replacing | the voltage selection switch ( D , F i g . 9 ) |
|
| |
_ _ _ _ _ |
|
|
|
|
1.Remove
2.Press in the four fixing legs on the switch and at the same time press out the switch from the control panel.
3.To replace switch, reverse the procedure.
3. Replacing the | G Fig. | 9) | |
_____ | _ _ _ | ||
1. | Unscrew union nut (H, | Fig. 9) | and union nut ( I, Fig. 9 ) |
2. Unscrew support bracket ( J, Fig 9) for
3.To replace
4.Replacing the thermostat and flame failure safety device ( Safety Valve)
___________
1. Remove
CAUTION: Only take hold of it at the left side (indicated by the arrow). N o w pull the capillary tube of the thermostat off.
2. Bend straight the capillary tube from the rear of the cabinet.
3.Unscrew union nut (A, fig. 11) from
