Philips FTR 9965/12 manual Connect Peripheral Equipment, Recorder VCR-DVD+RW, DVD player

Connect Peripheral Equipment

There is a wide range of audio and video equipment that can be connected to your receiver. The following connection diagrams show you how to connect them.

Note: In case of the monitor in a stand alone situation without the receiver box connected, see the instructions with the monitor.

Note: EXT1 can handle CVBS and RGB, EXT2 CVBS, Y/C and RGB, EXT3 and 4 CVBS, EXT5 Y-Pb-Br. It is preferred to connect peripherals with RGB output to EXT1 or EXT2 as RGB provides a better picture quality.

Note: If your recorder is provided with the EasyLink function, it should be connected to EXT2 to benefit from the EasyLink functionality.

Recorder (VCR-DVD+RW)

Note: Do not place your recorder too close to the screen as some recorders may be susceptible for signals out of the display. Keep a minimum distance of 0,5 m to the screen.

CABLE

	EXTERNAL
	2
1	2

Connect the aerial cables 1, 2 and, to obtain the optimum picture quality, eurocable 3 as shown.

If your recorder does not have a euroconnector, the only possible connection is via the aerial cable.You will therefore need to tune in your recorder’s test signal and assign it programme number 0 or store the test signal under a programme number between 90 and 99, see Manual installation, p. 6.

See the handbook of your recorder.

3

4

VCR 1

DECODER

Decoder and Recorder

Connect a eurocable 4 to your decoder and to the special euroconnector of your recorder. See also the recorder handbook. See Decoder, p. 10. You can also connect your decoder directly to EXT1 or 2 with a eurocable.

Other equipment (satellite receiver, decoder, DVD, games, etc.)

CABLE

14

2

EXTERNAL
1	2

5

3

&Connect the aerial cables 1, 2 and 3 as shown (only if your peripheral has TV aerial in-/output).

Connect your equipment with a eurocable 4 or 5 to one of the euroconnectors EXT1, 2, 3 or 4 to obtain a better picture quality.

éLook for the test signal of your peripheral in the same way as you do for a recorder.

“ Make a selection in the Setup, Source menu, p. 9.

VCR 1

DVD player

With Component Video Output Connectors (EXTERNAL 5)

	EXTERNAL 5		&
1	2 Y
	U	L
	V	R
			é

OUT

Connect the three separate component video cables to the DVD player’s Y, U (Pb) and V (Pr) jacks and to the Y, Pb and Pr jacks on the receiver.

Connect the audio cable to the DVD player’s AUDIO L and R jacks and to the L and R AUDIO EXTERNAL 5 jacks on the receiver.

DVD

19