Philips DVD757VR/02 manual Specifications, Troubleshooting

1 Vpp into 75 ohm

0.7 Vpp into 75 ohm Left/Right

Four heads Hi-Fi VHF/UHF - 75 ohm 75 ohm unbalanced

Compressed Digital

16, 20, 24 bits

fs, 44.1, 48, 96 kHz

Specifications

PLAYBACK SYSTEM

DVD Video,Audio CD, DVD+RW, DVD-R/RW,

DVD+R, CD-R/RW,VIDEO CD

TV STANDARD (PAL/50Hz) (NTSC/60Hz)

Number of lines	625	525
Playback	Multistandard	(PAL/NTSC)

VIDEO PERFORMANCE

Video output

RGB (SCART) output

Video Shift

VIDEO CASSETTE RECORDER

Video heads

Antenna

VHF output

AUDIO FORMAT

Digital MPEG

Dolby Digital

PCM

Analogue Stereo Sound

Dolby Surround-compatible downmix from Dolby Digital multi-channel sound

3D Sound for virtual 5.1 channel sound on 2 speakers

AUDIO PERFORMANCE

DA Converter 24 bits

DVD	fs 96 kHz	20 Hz - 44 kHz
	fs 48 kHz	20 Hz - 22 kHz
CD	fs 44.1 kHz	20 Hz - 20 kHz
Signal-Noise (1kHz)		70 dB
Dynamic Range (1kHz)		70 dB
Distortion and Noise (1kHz)		0.1%
CONNECTIONS
SCART	2x Euroconnector
S-Video OutputMini DIN, 4 pins
Audio L+R output	2x Cinch (white/red)
Digital Output 1 coaxial, 1 optical	IEC958 for CDDA / LPCM
	IEC1937 for MPEG1/2, Dolby
	Digital
CABINET
Dimensions (w x h x d)	435 x 99 x 218 mm
Weight	Approximately 3.8 Kg
POWER SUPPLY (UNIVERSAL)
Power inlet	220 ~ 240 V , 50 Hz
Power usage	Approx. 30 W
Power usage standby	9.2 W
	(standby : 5.0 W)
	(When CLOCK DISPLAY set to OFF.)

Specifications subject to change without prior notice

English

Troubleshooting

Problem			Solution
No power			–	Check if the AC power cord is properly connected.
No picture			–	Check if the TV is switched on.
			– Check the video connection.
	Distorted picture		–	Sometimes a small amount of picture distortion may appear.This is not a malfunction.
Completely distorted picture or			–	Connect DVD/VCR directly to the TV.
black/white picture with DVD			–	Make sure the disc is compatible with the DVD/VCR.
No sound or distorted sound			– Adjust the volume.
			–	Check that the speakers are connected correctly.
No audio at digital output			–	Check the digital connections.
			–	Check if the audio format of the selected audio
				language matches your receiver capabilities.
	No DTS audio at analog output		–	Use a DIGITAL AUDIO OUT jack when outputting the DTS audio.
No sound and picture			–	Check that the SCART cable is connected to the correct device (See Connecting to a TV)
Picture freezes momentarily during			–	Check the disc for fingerprints/scratches and clean with a soft cloth wiping from centre
playback				edge.
			– This may happen when you use the disc recorded in the non-seamless manner.This is not a
				malfunction.
Disc can’t be played			–	Ensure the disc label is facing up.
			–	Check if the disc is defective by trying another disc.
		No return to start-up screen when disc is	–	Reset the unit by switching the DVD/VCR off, then on again.
removed
The DVD/VCR does not respond to the			– Aim the remote control directly at the sensor on the front of the DVD/VCR.
remote control			–	Reduce the distance to the DVD/VCR.
			–	Replace the batteries in the remote control.
			–	Re-insert the batteries with their polarities (+/– signs) as indicated.
	Buttons do not work or DVD/VCR stops		– To completely reset the DVD/VCR, unplug the AC cord from the AC outlet for 5-10 sec-
responding				onds.
DVD/VCR does not respond to some operating			–	Operations may not be permitted by the disc.
commands during playback.				Refer to the instructions of the disc.
DVD/VCR cannot read CDs/DVDs			–	Use a commonly available cleaning CD/DVD to clean the lens before sending the DVD/VCR
				for repair.
	The DVD/VCR switches from DVD mode to		–	Playback will stop for more than 35 minutes and no button is pressed.
VCR mode after 35 minutes
The VCR do not record a TV program			–	Make sure the tape has a record tab.
			– Make sure the DVD/VCR is in VCR position.
			– Check the TV and the DVD/VCR channel are similar.
The DVD/VCR do not perform a timer			–	Make sure the recording start and stop times are set correctly.
			– Make sure the tape has a record tab.
			– Make sure the clock is set.
			– The DVD/VCR may not perform or continue a timer recording if the power fails for more
				than 1 minute.
The motor (cylinder) rotates even when tape			–	To enable quick play mechanism, the cylinder will rotate for about five minutes.This is nor-
playback is stopped				mal.
You cannot insert a tape			–	Insert a tape, window side up with the record tab facing you.
			– Gently push on the center of the tape when putting into the DVD/VCR.
	You cannot remove a tape		–	Make sure the power plug is completely connected to a power outlet.
DVD/VCR ejects the tape when you press			–	Make sure the tape has a record tab.
RECORD or TIMER SET for a timer recording.

If you are unable to remedy a problem by following these hints, consult your dealer or service centre (HOTLINE).

19