AudioControl manual Guided Tour of DQX

AudioControl®

A GUIDED TOUR OF DQX

1)Inputs: The DQX has two RCA inputs that need to get their audio signals from the main source unit. If your source unit has multiple outputs (like a front, rear, and/or subwoofer) you should only connect the front or rear outputs to your DQX.

2)Input Level: This knob allows you to maximize the signal level from your source unit that goes into your DQX to achieve maximum signal to noise. Keep in mind, that despite what the literature says, most aftermarket source units produce a relatively low voltage signal when it comes to playing music at normal levels.

3)Input Maximized Indicator: This nifty LED light indicates that you are supplying the DQX its maximum amount of signal voltage. If the LED indicator never comes on, don’t assume that it is not working (since LED’s rarely break) but you might consider adding a line driver to your system.

4)Output Level Controls: Although your DQX has the ability to increase your signal voltage, your amplifiers may not necessarily accept that much signal. These controls allow you to regulate the proper amount of pre-amp signal from the DQX to the amplifiers.

5)Equalization Overload Indicator: This convienient LED indicates when the DSP (digital

signal processor) of your DQX is clipping or distorting. The usual cause of this is having the “Input Level” turned up too high or you have boosted too many frequencies on your equalizer.

6)Select: This allows you to select one of the various equalization, crossover, or memory modes of your DQX.

7)Navigation Arrows: These multi-function buttons perform a number of functions, depending upon which mode your DQX is in. You can do any- thing from changing crossover frequencies to apply- ing boost or cut to your equalization filters. However, if you get the high score, you cannot enter your initials!

8)Output Voltage Indicators: These brightly colored LED’s indicate the level of signal voltage that is coming out of the various outputs of your DQX.

9)Outputs: These RCA connectors should be con- nected to the next components after the DQX, usu- ally an amplifier. Do not connect any speakers directly to your DQX or to any home appliances, like your toaster.

10)Power Connections: This nifty connector is a godsend to those who have tried to wire up their gear with their body crammed in the trunk. You can wire up the power, ground, and remote turn-on from the convenience of outside your car and then casually plug it into your DQX.

6 Owner’s Enjoyment Manual