Philips DVP 3055V owner manual Troubleshooting, Symptom Cause Correction

English

Troubleshooting

Check the following guide for the possible cause of a problem before contacting service.

Symptom	Cause	Correction
DVD or VCR do not	● DVD or VCR button is not switched	● Refer to page 6.
work properly.
	properly.
No power.	● The power cord is disconnected.	● Plug the power cord into the wall outlet
		securely.
The power is on, but the	● No disc is inserted.	● Insert a disc.
DVD player does not
work.
No picture.	● The TV is not set to receive DVD signal	● Select the appropriate video input mode on
	output.	the TV so the picture from the DVD player
		appears on the TV screen.
	● The video cable is not connected securely.	● Connect the video cable into the jacks
		securely.
No sound.	● The equipment connected with the audio	● Select the correct input mode of the audio
	cable is not set to receive DVD signal
		receiver so you can listen to the sound from
	output.
		the DVD player.
	● The audio cables are not connected	● Connect the audio cable into the jacks
	securely.	securely.
	● The power of the equipment connected	● Turn on the equipment connected with the
	with the audio cable is turned off.	audio cable.
	● The Digital Audio Output is set to the	● Set the Digital Audio Output to the
		correct position, then turn on the DVD
	wrong position.
		player again by pressing POWER.
The picture is poor.	● The disc is dirty.	● Clean the disc.
	● The TV channels are not tuned in properly.	● Check tuning, carry out tuning again.
The DVD player does not	● An unplayable disc is inserted.	● Insert a playable disc. (Check the disc type
start playback.		and Regional code.)
	● The disc is placed upside down.	● Place the disc with the playback side down.
	● The disc is not placed within the guide.	● Place the disc on the disc tray correctly inside
		the guide.
	● The disc is dirty.	● Clean the disc.
	● The Rating level is set.	● Cancel the Rating function or change the
		rating level.
The remote control does	● There is an obstacle in the path of the	● Remove the obstacle.
not work properly.	remote control and this unit.
	● The batteries in the remote control are	● Replace the batteries with new ones.
	exhausted.
Video tape cannot be	● Is the cassette compartment empty?	● Eject the tape in.
inserted.
No Hi-Fi sound	● Audio mode is not set properly.	● Switch ‘AUDIO’ in the main menu to
		‘STEREO’.
No NICAM sound	● NICAM mode is not set properly.	● Make sure NICAM in the menu is set to
recording		AUTO for the station to be recorded.

34