Check the smart card
Check whether the UPC smart card is inside the front slot of the Digital Cable Receiver.
If this is not the case, slide it in the slot:
•Open the smart card door on the right side of the box.
•Insert the smart card into the smart card slot as far as it will go.The end of the card will be visible from outside the slot.
Warning
Insert the smart card with the chip facing down.
4.2Connect
Danger
Risk of electric shock!
Make sure all the devices are disconnected from the mains before making any connections.
HDMI connection
Cable Wall |
|
Socket | Digital Cable Receiver |
TV set
Connect the coaxial cable from the cable wall socket to the RF IN socket at the rear of the Digital Cable Receiver.
Connect the HDMI cable to the HDMI input of the TV set and to the HDMI socket at the rear of the Digital Cable Receiver.
Plug your Digital Cable Receiver to the mains using the supplied power cord.The front display panel indicates Init, then UPC.
Note
For scart connection, refer to chapter 7.2.
4.3Install
Before you start installation, make sure you have made all the required connections.
Switch on your TV set.The country selection screen appears. In that case, the Digital Cable Receiver has automatically started up at connecting.
Note
If you can’t you see the country selection screen, switch on the Digital Cable Receiver by pressing at the front of the Digital Cable Receiver or press the remote control. In case you still can’t see this screen, check whether your TV is set to the right A/V (Audio/Video) channel.
Read the manual of your TV set if you do not know how to set the A/V channel. In case you still can’t see the screen, check all connections and start installation again. If everything is properly connected and you still can’t see the country selection screen, after multiple efforts, please contact UPC Customer service.
Warning
Do not switch off the Digital Cable Receiver during activation.
Also pay special attention to children, so that they cannot interrupt activation, for example by pulling the plug from the socket of by pressing on it.
69 | Getting started |